stewaj11

iTrader: (5)

I have an opportunity to pick up a brand new set of uncoated pacesetter LT's for 200$, my question is should I pick them up and send them to jet hot and get their coating put on them? And if so how much would that run me? Ive been researching headers now for awhile and its time for me to pizk a set up. Thanks for any input...

transamLs1

i have quick trip pacesetter 1 3/4" LTs and they were uncoated for 137 after shipping. so i say bad deal.

transamLs1

unless did you mean 200 with the coating?

stewaj11

iTrader: (5)

no 200 with out, I havent seen them for that low anywhere... I know in the sponsor forums they go for around 280 if im not mistaken?

transamLs1

well i bought mine on ws6store.com it was either there or a link to there. you have to keep an eye out for deals if i have spare time i will just tell me exactly what your looking for i have a nack for finding awesome deals!

squale iii

you're fucked. I have pacesetter LT's, and it's been 8-10 months and they are almost rusting through right before the collectors already... My tuner said I have maybe another 6-12 months before it develops small holes. I should have gotten some kooks or something nice...wish someone had told me this before i spend $300 on these shitty headers.

stewaj11

iTrader: (5)

Ya that would be great, I have a 98 TA and im looking for a nice set of long tubes, I need them to be coated or I will have to send them out to get it done, I really dont have a brand preference it is my DD but I will do the maintanence on them like wiping off the dorosion and such. And I will need a Y-Pipe as well. Im just lookin for the best bang for my buck and pacesetters or hookers seemed to be a good choice. If you could find me something like that, that would be awesome. I have been looking and it seemsthe going rate for new PS are about 370.00 roughly

transamLs1

hes getting them coated

Jersey Mike

iTrader: (9)

Man, i was in your shoes not too long ago.
I bought a set of uncoated P/S LTs from a forum member. They are not rusted, and I still haven't installed them yet, but I'll be spraying them with a full can of FluidFilm before I install them (since they're not coated and I live in the Northeast), and I'll see how that holds as the months pass by.
link: https://ls1tech.com/forums/appearanc...ing-great.html

Mean87SS

iTrader: (21)

My car is not my daily... and my PS headers that were coated are all shitty by the collecters.

stewaj11

iTrader: (5)

Is it that the PS coating isn't that good? So I should buy some that are uncoated and send them to an outside coater to have it done right? I just don't know how much that would run me. I don't want to slap some junk on my car thats gonna rust out in a year, but on the other hand I can't justify dropping 800-1000$ on headers. So any info you experienced guys can give me is good info.

transamLs1

hey all i found were uncoated for 299 no deals right now but im about to start a new job i might get a bad *** discount on parts so i will still check around.

The Postman

iTrader: (44)

I have around 70,000 on my pacesetters and they have not given me any problems....paid 300 used for a set of coated ones....they were in perfect condition then and are still great today.

best bang for the buck...hands down.

SMOKNSS

iTrader: (3)

I've had my pacestters for about 3 years and have had NO problems.

bagged36

iTrader: (1)

I know several people that run pacesetters with no problems