99ccz28

iTrader: (6)

Just got my nitrous hooked up. When I open the bottle the nitrous just shoots right through the purge. What could be the problem? Thanks!

Speed Density

iTrader: (38)

Where at on the purge? The fittings? Or the hardline itself?

Tony.

99ccz28

iTrader: (6)

The actual hardline.

StreetnStrip

iTrader: (7)

Is the purge button stickin?

99ccz28

iTrader: (6)

No its not, but it acts as if it is.

StreetnStrip

iTrader: (7)

unhook the 2 wires from the switch and see if it still does it.

99ccz28

iTrader: (6)

I unhooked both wires off the switch and it still shot right through.

fstphx

iTrader: (5)

Either wired wrong or noid stuck open-
Running a relay?

StreetnStrip

iTrader: (7)

I know I personally tested it after it was installed and it worked fine. I was either thinking its the switch or maybe the noid is stuck open.

99ccz28

iTrader: (6)

So its a bad noid? Nothing I can do to fix it?

StreetnStrip

iTrader: (7)

it could be check ur PM's

gr8one99SS

iTrader: (4)

you dont happen to have the inlet/outlet backwards?

fstphx

iTrader: (5)

hooked straight to the switch or through a relay?

99ccz28

iTrader: (6)

Im am not sure. I think it has a relay. I purchased the installation kit and everything from HSW.

gr8one99SS

iTrader: (4)

i hooked up my purge with the feed line to the output once and it did what your describing

99ccz28

iTrader: (6)

I disconnected the ground wire to the purge and it still went right through the purge hardline.

99ccz28

iTrader: (6)

They put the noid on backwards. Now I just have to get some paste and fix the leak and should be good to go!

bigleman

iTrader: (1)

i dont think i'd go back to a shop that cant figure out a simple nitrous noid

99ccz28

iTrader: (6)

They are a pretty good shop. But, there is not way anyone tested like he said, he shouldn't have lied. I was already told it was not tested. Unless he tested it and knew it wasn't working right

StreetnStrip

iTrader: (7)

First off there is always two sides to a story. Our shop rarely installs nitrous kits but being he bought the car off of us we wanted to take care of him. This past week our shop was crushed with work and we wanted to get his car done for him as promised. So we had to hire someone from outside to come to our shop to install it. The guy who did it installs nitrous kits alot so I had faith in him. Yes maybe I should have had his worked checked over but the guy told me it was setup right and it worked fine for him.