Proline 383 Stroker Motor
#1
Teching In
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: Suffolk, Virginia
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Category: Engine - Complete Motors
Price: $3400
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird
Location (State): VA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: Small Block
LS Engine?: Non-LS Part
I have a 350 that was stroked out to a 383. Here's a list of parts:
-SCAT 4340 STEEL CRANK
-SCAT I-BEAM RODS 6IN POWDERED
-HYPEREUTECTIC FLAT TOP 10.5-1 PISTONS
-I PIECE REAR MAIN SEAL
-HIGH FLOW OIL PUMP
-DOUBLE ROLLER BILLET TIMING SET
-CUSTOM GROUND CAM TRUE ROLLER .505 INT .510 EX LIFT @ .050 108 CENTER LINE DUR@ .050 224INT 230 EX LOBE SEP 112
-COMP ALUM 1.5 ROLLER ROCKERS
-SCREW IN STUDS ALL ARP FOR RODS AND ROCKERS
-PROLINE ALUMINUM HEADS 68 CC PORTED AND FLOWED GOOD UP TO .600 LIFT
-EDELBROCK BASE INTAKE AND RUNNERS COMPLETELY PORTED AND MATCHED TO RUNNERS AND HEADS LOWER INTAKE WAS ADDED ON TO AT INTAKE PORTS THEN REPORTED TO MATCH HEADS DUE TO SIZE OF INTAKE PORTS ON HEADS UPPER CENTER INTAKE PORTED TO MATCH TWIN 58MM THROTTLE BODY (BBK)
-30 lb inj holley
-adj fuel pressure regulator bbk
-edelbrock coated shorty headers with custom y pipe
-gear redudtion starter and approved fly wheel
This was in my IROC project car that didnt get finished cause I have the GTO and too busy trying to get it done to work on this anymore. Basically brand new other then starting it up after build. Heads alone are worth this price.
Here are some pics and motor has pollen on it from were it was outside when pollen first fell this season but will be cleaned up before shipping. Paypal is joshandjojo@***.net and you can reach me at 757-618-0241.
Josh
http://i250.photobucket.com/albums/g...s/IMG_1333.jpg
http://i250.photobucket.com/albums/g...s/IMG_1334.jpg
http://i250.photobucket.com/albums/g...s/IMG_1335.jpg
Last edited by josh1; 07-13-2010 at 07:25 PM.
#6
Teching In
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: Suffolk, Virginia
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Not breaking down parts on motor unless I have more people wanting other parts. Just wouldnt be cost effective at this point.
Bump for a basically brand new 383 stroker that is worth way more then what I am asking. Need this gone before wife kills me lol
Bump for a basically brand new 383 stroker that is worth way more then what I am asking. Need this gone before wife kills me lol