Mezire, 96lb injectors, katech tensioner, wiring harness, etc....
04-19-2011, 03:17 PM
#1
On The Tree
Thread Starter
iTrader: (31)
Join Date: Mar 2008
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Mezire, 96lb injectors, katech tensioner, wiring harness, etc.... Category: Racing Parts
Price: $250
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Front wheel drive vehicles
Location (State): MI
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
Mezire waterpump (part number WP319R) SOLD : 55GPM block mounter water pump. I purchased this online used. I cannot get my belts to clear the pump so I am going to have to run a stock pump.
Comes with 160 degree thermostat in matching red anodized thermostat housing. 2000 miles on pump.Katech tensioner (part number KAT-A4425) SOLD: matching anodized as the water pump. Helps keep from throwing belts at high rpm runs.
96# low impedance injectors. sold: These I bought while I was in school and had them all cleaned and flow tested. They have not been used since.
Factory 2000 Firebird steering wheel. $50.00: has the radio buttons and is flawless. all buttons work. I just upgraded to a Sparco
Drivers airbag $50.00: Who ever has to buy this I feel bad for your face. But more importantly I hope the car is okay.
98 wiring harness and PCM: (pending payment) $250.00: Harness is from an automatic transmission z28. Maf wiring has been extended a foot and map sensor has new connector to accept the newer map sensors. Comes with a map sensor. No clue what the map sensor is for but if you pm me within the next 5 minutes the map sensor is your gift free with purchase. I needed 3 bar SD for my turbo build so I had to upgrade to a 2002.
Last edited by jrocstar; 04-20-2011 at 10:30 AM.
04-19-2011, 05:18 PM
#3
On The Tree
Thread Starter
iTrader: (31)
Join Date: Mar 2008
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
I bought it and was told about 1000. I personally only used it to mock up and realized the belt routing wont work with it. The guy I bought it from said he popped a piston about 1000 after his build and was parting it all out. Parts all are plus shipping.
04-19-2011, 06:15 PM
#7
On The Tree
Thread Starter
iTrader: (31)
Join Date: Mar 2008
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
no its fine. I just took a look at what they cost new at a couple places. Thats why in the intro if people think the prices are high let me know. i appreciate it. I am not out to gouge anyone.
