GNXClone

iTrader: (7)

Category: Engine - Intake/Fuel
Price: $250
Part Fits: 04-06 Pontiac GTO
Location (State): FL
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9
LS Engine?: Fits LS Engine

Stock LS2 rotating assembly from a 2006 GTO with approx 40,000.

#7 was replaced with a good used rod and piston.

Crank has the 24x reluctor wheel and includes a factory installed pilot bearing for a T56. Will also work with automatic trans without removing the pilot bearing.

SOLD

Kory 88Iroc Lt1

iTrader: (7)

Is the rotating assembly ready to go or will it require balancing or anything?
Thanks,
Kory

bohr898

iTrader: (6)

pm sent

GNXClone

iTrader: (7)

It's ready to go balance-wise. I would recommend new rings and bearings.

It was removed from the LS2 in my GTO. The replacement rod and piston are the same part# as the originals. Since I had to tear the engine down anyway, I decided to lower my compression to 9.5:1 by installing a complete rotating assembly out of an LY6 engine.

cyclerage

iTrader: (59)

pm me a price shipped to nj 08879
Why did you need to replace #7 hammer and handle?
Any pics of the bearing surfaces on the crank?

GNXClone

iTrader: (7)

Rain water went into #7 and bent the rod. All other cyls were dry.

Will post close up shots of the journals later today.

GNXClone

iTrader: (7)

I had the crank polished and cleaned today at Total Engine Concepts in Riveria beach.

Pics attached

GNXClone

iTrader: (7)

Sale pending. If not sale is not concluded by Sunday Sept 25, this will be available again

Sale concluded. Thanks Matt!