FS: 97 timing cover, Accel 30lb Injectors, Stock heads, Milled heads, WP, Lifters
10-06-2011, 04:17 PM
#1
FS: 97 timing cover, Accel 30lb Injectors, Stock heads, Milled heads, WP, Lifters Category: Engine - Power Adders
Price: $1
Location (State): CA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
LS Engine?: Non-LS Part
All parts are from a 1997 Camaro Z28 that was used for road racing only for the past few years. The build spun a bearing and was pulled for an LS1 setup. Very low mileage on most parts. I will have more pictures soon (just ask if you don't see the one you want).
All prices are OBO. For shipping quotes PM me your zipcode and let me know if you have a business address for cheaper rates. I ship by Fedex.
TONS OF PICTURES: https://picasaweb.google.com/1087816...rs6obSuOr_nAE#
Accel 30lb/hr Fuel Injectors - $99 PLUS SHIPPING
Injectors have about 1k miles on them and they were working fine when removed.
97 LT1 Timing Cover (with cam sensor) - $55 PLUS SHIPPING SOLD
The cover doesn't have any issues, but you you may want to check the sensor seal when you install it on your engine. The sensor worked fine before the engine was pulled and parted out. **This is the cover you want to do an LS1 PCM conversion.
Stock LT1 Intake Manifold - $39 PLUS SHIPPING SOLD
This manifold is stock and in good condition. I can include fuel rails and a stock regulator for $10 extra if bought together..
LT1 Lifters (low miles) - $35 SHIPPED SOLD
The lifters have about 300 miles on them and are in great shape. They just need to be cleaned before use.
LT1 Fuel Rails and Stock Regulator - $15 PLUS SHIPPING
Stock without any issues.
Stock LT1 Heads with Comp Double Springs Good to .600 - $140 PLUS SHIPPING SOLD
These heads were pulled off one of my old cars that had a GM847 cam. The springs had about 5k miles on them and the heads are otherwise stock. These are ready to run and came of a 97 and are 374 castings.
LT1 Heads Milled to 54cc w/ Comp Double Springs - $140 PLUS SHIPPING
These heads were used on the 355 that is for sale here. They are milled for more compression and have springs that good until .600. I ran a GM846 cam with these heads. The ports and valves are stock other than a valve job. These are 374 castings off a 97 lt1.
PowerBond 80030 LT1 Harmonic Balancer (not SFI) - $25 PLUS SHIPPING SOLD
This balancer has about 300 miles on it and is not SFI approved but still a nice upgrade from the stock balancer. It is neutral balanced (like stock) and will bolt right up.
Stock LT1 Waterpump - $19 PLUS SHIPPING
The waterpump has about 5k miles and is not a GM part. Some of the ports are blocked off (oil cooler/heater etc).
Last edited by Tireburnin; 01-01-2012 at 10:43 AM.
