finally have my VE where i want and the car running in SD perfect(+/-3) So i reset my FTs and i went to drive it for a highway pull and at wot from 2-5800 it is around 16-17.1, lastnight when i logged it was around 12.0-12.5.. my VE table has barely changed since lastnight. PE table is identical. Any ideas?

 

TPS High voltage code pending? eg. did you grind on your bump stop?

 

post the tune and log file

 

Frost - the bumpstop mod i did a long time ago before the problems arose, maybe its going bad? i put a solid 120-130mi on the car tonight and its still not richening up.. the FT's should be learned by now.

 

ill get them up tommorrow morn as they are on my other cpu.

 

Also just looked in the car and i have 2 codes for "no input from 02 sensor" wonder if this could have something to do with it?

 

post the tune and log!

 

log will be up shortly, i think i had a wiring issue, but here is the tune.

 

p0101-p0103 MUST be set to fail on first (not 'no error reported') though you can leave the SES box unchecked. Give that a try before changing other areas, it may have actually kept you out of true SD.

 

I just set them to MIL on first error, going out to log right now.

 

I think that was keeping it from going into SD. Heres the log, the 02 code is gone, and at wot it went 12.2 Frost, could you still look at my log and tell me how you think the tune is for the car? id greatly appreciate it

 

You have LTFTs over 10% positive so you may have a little work left on the VE table here and there.