tapping pcm
Thread Starter
Joined: Dec 2009
Posts: 404
Likes: 1
From: corpus christi, texas
tapping pcm i just completed a transmission swap and i want to wire up the reverse lockout to the pcm. what is the best way to tap into the pcm to do so? and what will i need?
thanks
thanks
TECH Regular
Joined: Feb 2003
Posts: 444
Likes: 1
From: Bahrain
If it's 99+ then use pin 44 from the red PCM connector to supply ground to the soleniod. You have to supply 12V ign to the other pin.
Buy the pins and plug them into the proper slot in the connector.
The connector is a PITA to take apart tho.
The connector is a PITA to take apart tho.
Trending Topics
TECH Regular
Joined: Feb 2003
Posts: 444
Likes: 1
From: Bahrain
1- Pin 42 tan/black, TCC enable circuit.
2- Pin 47 yellow/black, shift solenoid B
3- Pin 48 ligh green, shift solenoid A
You can use any one of the three, and will have to extend the wire at the other end (trans) since the rev. sol. is on the driver side and the auto trans connector is on the passenger side of the trany.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
