JayTS

iTrader: (1)

Oh come on, we need more teasers than that! Pics or don't post! haha, hope the build is going well.

03EBZ06

Ok, getting close. SUPPOSED to have it engine dynoed on 8/8/16. I hope everything goes smoothly.

Pic of the engine w/CP Pistons.

More pics to come soon!

tug686spd

iTrader: (11)

Has she made any noise yet?

03EBZ06

Well it's this Thu or Mon. Coordinating this circus is a pain....

briannutter

All reputations shot to hell.

03EBZ06

Pic of new engine. We fired it on the dyno today. Took me a little while to get the tune file coordinated for the harness since we used a F body style TB and not my drive by wire.

Tomorrow the magic happens, full throttle pulls. Ran out of time today.



LS3 416 Mast 265cc heads, Comp Cams SR, T&D rockers, LS7 Holley Hi Ram.<br/><br/>

tug686spd

iTrader: (11)

Good luck. They say the best things come to those that wait. And I believe youve got some wait time in on this one.

HighspeedLean

iTrader: (2)

Is it tomorrow yet?

03EBZ06

What I know so far:

This heads and intake combo is killer. I am trying to figure out how to make sure the oil supply stays up w/the engine. Its accelerating hard at 7400rpm and the dyno guy said he believes will peak around 8500rpm. Dyno stopped at 7400rpm to give the new engine a break and for oil system.

Likely moving to a smaller cam. More info to come...

speedtigger

iTrader: (16)

So glad to see you getting good result. You have been through a lot to get there.

HighspeedLean

iTrader: (2)

Is it just me or do those dyno headers look to be on the small side...?

Also at 13-1cr, what timing you at and what have you tried?

Smaller cam....from what is in it currently to....? In this thread, a lot of cams were spoke of, but what was installed initially?

03EBZ06

Its you. Those are 1-7/8" headers, though not mine. I'll be posting data in the near future.

JayTS

iTrader: (1)

any updates? This setup sounds like a wet dream.

03EBZ06

expecting results late this week...I'll post out once some results settle out. we yanked the first cam, was going to pull to the moon, beyond the oil system. put something a bit smaller in. should see that result this week.

KW Baraka

iTrader: (7)

What were the specs of the cam you initially put in it?

KW

03EBZ06

comp cams cr solid 268/280-114+0.

KW Baraka

iTrader: (7)

Whoa!!!!!!

That is a lotta cam!

KW

BOLO

iTrader: (40)

Then a I have a lotta cam for my build.

speedtigger

iTrader: (16)

What was the lash setting on that camshaft and what RPM peak are you shooting for?

03EBZ06

8000rpm max. that was a good cam but not willing to spin past 8