LED flasher for LED front & rear
Thread Starter
Joined: Dec 2004
Posts: 3,460
Likes: 12
From: Lawndale, CA (310)
LED flasher for LED front & rear I am going to swap out the front and rear bulbs to LEDs. I have done some research and have seen a few flashers that supposedly work.
I have seen the following one's recommended:
EF32RL
LL552
CF12ANL-01
Trying to figure out which one would work.
This would be for my 2002 Camaro SS.
Thanks.
I have seen the following one's recommended:
EF32RL
LL552
CF12ANL-01
Trying to figure out which one would work.
This would be for my 2002 Camaro SS.
Thanks.
Joined: Nov 2003
Posts: 11,328
Likes: 345
From: Jacksonville, FL (originally from Toronto Canada)
Of those three, only the CF12ANL-01 is designed to be completely "no load" for use where all bulbs have been replaced with LEDs. Some people have been able to get the EF32RL to work with all LED bulbs while others have not so I wouldn't rely on it. The LL552 is electromechanical and definitely won't work without a load.
Copy & Paste Moderator
Joined: Apr 2002
Posts: 9,764
Likes: 208
From: Eastern MA
I used a "Keep It Clean FF552NLF No Load Fixed Flasher" that I bought on Amazon for $15 delivered.
Thread Starter
Joined: Dec 2004
Posts: 3,460
Likes: 12
From: Lawndale, CA (310)
I used a "Keep It Clean FF552NLF No Load Fixed Flasher" that I bought on Amazon for $15 delivered.
Amazon.com: Keep It Clean FF552NLF No Load Fixed Flasher: Automotive
Amazon.com: Keep It Clean FF552NLF No Load Fixed Flasher: Automotive
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Launching!
Joined: Apr 2015
Posts: 237
Likes: 1
From: Henderson NV
Here's mine and the parts/prices I purchased. 6 years going strong, no issues.
....and like "VIP1" said.....a synthetic "tock" sound is how mine sound too.
https://ls1tech.com/forums/appearanc...light=flashers
.
....and like "VIP1" said.....a synthetic "tock" sound is how mine sound too.
https://ls1tech.com/forums/appearanc...light=flashers
.
hmm i may have to buy that one...i bought a flasher since i have leds in the front and the one i bought makes no noise at all. At first i didn't mind it but now alot of times i forget my signal is on
I tried the new flasher today with LED bulbs in all four corners. The turn signals work fine, but I didn't think of the hazard flasher... hazards don't work, so I'll change that one when the second shows up, lol...
hazards use another flasher on the driver side of the dash lol
ok not trying to hijack but just adding on, well I added LED switchbacks fro Astar and well the drivers works and his bright white but doesn't blink and the passenger side starts out white and does blink orange but then will not switchback at all and that's with the car not started once I start the car the passenger side front turn signal stays solid orange? now I replaced the turn signal flasher with the EL12 flasher from vatozone but do I need to replace the hazard flasher as well?
Joined: Nov 2003
Posts: 11,328
Likes: 345
From: Jacksonville, FL (originally from Toronto Canada)
Sounds like the right (passenger) side is working as designed. Those switchback bulbs have white for parking lights (normally the dim filament of a 3157 bulb) and amber for the turn signals (normally the bright filament of a 3157 bulb). F-bodies use the turn signal circuit for daytime running lights so the switchbacks will be solid amber when the ignition is on and the parking brake is released except for when your headlights are on.
The driver's side doesn't seem to be making a connection for the DRL/turn signal circuit. That could be the bulb's wire contact is bent out of position, the bulb is reversed, the socket is corroded, or something is wrong with the blue wire into the socket.
The driver's side doesn't seem to be making a connection for the DRL/turn signal circuit. That could be the bulb's wire contact is bent out of position, the bulb is reversed, the socket is corroded, or something is wrong with the blue wire into the socket.