nwilson44

Finally got to run this car! It's a FBO E85 5.0 with Mickey's and littles. Said he did weight reduction so his car is 3300. Not completely gutted but getting there. Car revs to 7900. Runs low 10's on spray.

40 roll- he jumps a bit but I start to pull immediately, then as I change into third he starts pulling me. By the time I go into 4th he has about a car on me and that's where it stays.

A bit bummed I didn't get em. But I'll get a fast 102 and re run it. It ran hard! Video coming soon. Bammarroww got beat fair and square. I'll get some more mods and try again!

nwilson44

Here's the video

V8EATR

Good runs, a well set up e85 bro is tough to beat.

madmike9396

iTrader: (29)

Good try

big hammer

Ls1/6 and coyotah are a good match mod for mod

nwilson44

Yeah he definitely has more mods with weight reduction, E85, manifold, and whatever else I don't have. I'll rematch when I get more mods.

corysmach1

Thats very true. OP re run again daytime in car vids. Good runs.

islander033

Good pull!

Fast02Z06

iTrader: (1)

damn good run man, not bad at all. Awesome as well for posting l's.

HCI2000SS

iTrader: (2)

I'm surprised it was that tight. Nice work!

HioSSilver

iTrader: (8)

I'm not surprised. ...a few changes snd you will walk him real good

Good run

I'm getting a error on the vid tho

Deeohgie69

iTrader: (3)

Me too, it only plays half way.

Good run man!

BlkMach1

Cam bolt on LS6 vs a full bolt on coyote? What manifold did he say he had? Besides that hes likely intake/headers/exhaust/e85 tune car. The weight reduction is a big plus for him.

nwilson44

He runs a CJ manifold. Sorry about the video I'll see what's up. So I guess everyone was expecting a worse loss lol?

nwilson44

Try going to you tubes website instead of the plug in. That's what I did and it worked.

HCI2000SS

iTrader: (2)

Based on his mods combined with the weight reduction I thought he'd pull on you a little more. Which is to imply that your car runs really good for the weight and mods it has

nwilson44

Yeah I didn't really know what to expect lol. I knew he had traction cuz of bigs and littles. After I knew what he had done I kinda expected it too. I'll go back with at least a FAST 102. Hopefully a set of heads too. I should be able to get him pretty good then?

HCI2000SS

iTrader: (2)

Definitely should have no problems with better heads and intake.

Mike Morris

iTrader: (55)

Crank scraper, pulley,bigger MAF with adapter,port your throttle body,truck coil with new wires(change your dwell time in your tune) and redo intake tubing is all you need.

HioSSilver

iTrader: (8)

You don't need heads. Get you a fast 102.....a 90 woukd be fine to. Either way be sure it's ported and dump that ls7 clutch for something much lighter and you will rail him

If you want to run guys like that pick you up a drag pak and do a little weight reduction . Be a cake walk.