2016 Camero SS vs 5.br0
#101
11 Second Club
Thread Starter
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Not just the motor. The a8 is a year newer. Also the pcm in the camaro is trickier.
Guy just went 10.8@126 with a converter and cam. DA was around 2500 and temp was 85f. Just an average joes car with a drag pack. Not stripped. Mid ten second car NA with stock heads this fall. Probably near 130 mph. Just insane performance for so few mods. Oh and he has a 150 shot it's set up for and he was running the nitrous tune. Car made 515 rwhp through the a8.
Guy just went 10.8@126 with a converter and cam. DA was around 2500 and temp was 85f. Just an average joes car with a drag pack. Not stripped. Mid ten second car NA with stock heads this fall. Probably near 130 mph. Just insane performance for so few mods. Oh and he has a 150 shot it's set up for and he was running the nitrous tune. Car made 515 rwhp through the a8.
#102
TECH Fanatic
iTrader: (13)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Still stock intake manifold and heads though.
Gpi stage 4 cam. Rhino sells them. He could give more details im sure. It's a big cam probably good for ~80 rwhp.
I thought it was impressive for one of the first known cam only builds in average conditions etc.
It made 515 na. 64x on the juice. He's expecting 9s
#103
11 Second Club
Thread Starter
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
No it had longtubes, CAI and e85. You know the terminology for cam only. Most have supporting mods. Converter was a 3600. They will actually make good power with the stock tri y and cam but not quite as good.
Still stock intake manifold and heads though.
Gpi stage 4 cam. Rhino sells them. He could give more details im sure. It's a big cam probably good for ~80 rwhp.
I thought it was impressive for one of the first known cam only builds in average conditions etc.
It made 515 na. 64x on the juice. He's expecting 9s
Still stock intake manifold and heads though.
Gpi stage 4 cam. Rhino sells them. He could give more details im sure. It's a big cam probably good for ~80 rwhp.
I thought it was impressive for one of the first known cam only builds in average conditions etc.
It made 515 na. 64x on the juice. He's expecting 9s
#107
10 Second Club
iTrader: (8)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Nothing delusional here. The ls/lt stuff just flat wears out the coyote stuff n/a.
Full 8000 rpm+ road race screamer built bottom end, heads, cams and on race fuel absolute full sausage to the max livernois coyote barely hit 600 hp on an engine dyno. With no bottom end and no driveability.
An lt1 and even ls3 can hit that with a backyard build with off the shelf parts on 93 octane and still have bottom end. And THEN after that they aren't cube limited.
NA for NA it's not even a contest. It's comparable to an ls1 in realistic max NA hp output. Welcome to 1996 Furd...![Winky](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_wink.gif)
An lt1 and even ls3 can hit that with a backyard build with off the shelf parts on 93 octane and still have bottom end. And THEN after that they aren't cube limited.
NA for NA it's not even a contest. It's comparable to an ls1 in realistic max NA hp output. Welcome to 1996 Furd...
![Winky](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_wink.gif)
No i like e85. It's not in my neck of the woods. I also see no purpose in talking hp numbers with engines on 2 different fuels. It skews the outcome. I've been around professional racing.......where they test fuels.
#108
Staging Lane
iTrader: (1)
Join Date: May 2009
Location: Clear Lake Tx
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Pretty close poppa and I think I might know who ultra is talking about (if it's the same guy). The shop I went to dyno'd a bone stock ss a8 and it made 409 to the ground in 92 degree texas heat. There is a guy in the Baytown area (Houston) with a white ss on drag pack, cam, and a tune, and a 3600 converter who did clock a 10.85 on motor. I hoestly cannot remember what he trapped bc of bs rumors floating around.
#109
TECH Fanatic
iTrader: (6)
Join Date: Sep 2008
Location: DSM
Posts: 1,433
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Pretty close poppa and I think I might know who ultra is talking about (if it's the same guy). The shop I went to dyno'd a bone stock ss a8 and it made 409 to the ground in 92 degree texas heat. There is a guy in the Baytown area (Houston) with a white ss on drag pack, cam, and a tune, and a 3600 converter who did clock a 10.85 on motor. I hoestly cannot remember what he trapped bc of bs rumors floating around.
#110
#112
TECH Fanatic
iTrader: (13)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Pretty close poppa and I think I might know who ultra is talking about (if it's the same guy). The shop I went to dyno'd a bone stock ss a8 and it made 409 to the ground in 92 degree texas heat. There is a guy in the Baytown area (Houston) with a white ss on drag pack, cam, and a tune, and a 3600 converter who did clock a 10.85 on motor. I hoestly cannot remember what he trapped bc of bs rumors floating around.
Looks like a kick *** build. It was 85f for the run and the slip didn't say time of day but it was 2-3k DA most of the day. Hasn't had a whole lot of time since the cam install it looks like. Should go plenty faster especially in the fall.
http://www.camaro6.com/forums/showth...427506&page=19
post 262
http://www.camaro6.com/forums/showthread.php?t=438063
build thread
#113
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Noticed a lot of real world times in the last 2 pages, high 11s with test pipes tune and DR with a 115 trap. 110-112 stock or stock with intake running mid to high 12s.
#114
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I would hope someone in their 40's has raced more than a mid 20's guy. ![Icon Lol](https://ls1tech.com/forums/images/smilies2/icon_lol.gif)
Does Marc ever race anyone?
When your own last street race was in 2013 and last slips posted were in 2014
You crack me up
To answer your question, yes, I do race - more than you as of late has been documented.
![Icon Lol](https://ls1tech.com/forums/images/smilies2/icon_lol.gif)
Does Marc ever race anyone?
When your own last street race was in 2013 and last slips posted were in 2014
![Icon Lol](https://ls1tech.com/forums/images/smilies2/icon_lol.gif)
To answer your question, yes, I do race - more than you as of late has been documented.
#116
TECH Fanatic
iTrader: (13)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
They can click off times as fast or faster than the all time quickest stock s550s in crap DA/conditions with no driver and or prep. The same situations in which the s550 is a 13 second car.
They are a half second gap stock for stock...old news.
#118
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
nice job ignoring temps, DA and 60 ft times. He ran 12.1 @ 115 earlier in the year stock on stock tires in 2100 DA. test pipes...4hp...pump tune 8-10 hp...he didn't improve on his 60 much if at all IIRC with those DRs...crappy prep that night.
They can click off times as fast or faster than the all time quickest stock s550s in crap DA/conditions with no driver and or prep. The same situations in which the s550 is a 13 second car.
They are a half second gap stock for stock...old news.
They can click off times as fast or faster than the all time quickest stock s550s in crap DA/conditions with no driver and or prep. The same situations in which the s550 is a 13 second car.
They are a half second gap stock for stock...old news.
#119
TECH Fanatic
iTrader: (13)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Well...he ran a 12.1 @ 115 with 2100 DA. Id consider mineshaft under sea level...hence the mineshaft term. Those test pipes are secondary cat deletes. They gain near 10hp if you remove the primaries. The secondary delete is more of a sound mod.
How does that compare to your bone stock times in that DA?
Your track could also be slower than just what the DA shows....that's just one aspect.
Id be surprised to see a stock s550 quicker than ~12.8 in 2000+ DA.
#120
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Well...he ran a 12.1 @ 115 with 2100 DA. Id consider mineshaft under sea level...hence the mineshaft term. Those test pipes are secondary cat deletes. They gain near 10hp if you remove the primaries. The secondary delete is more of a sound mod.
How does that compare to your bone stock times in that DA?
Your track could also be slower than just what the DA shows....that's just one aspect.
Id be surprised to see a stock s550 quicker than ~12.8 in 2000+ DA.
How does that compare to your bone stock times in that DA?
Your track could also be slower than just what the DA shows....that's just one aspect.
Id be surprised to see a stock s550 quicker than ~12.8 in 2000+ DA.