Epic SRK B/S thread of 2019
#8781
10 Second Club
iTrader: (8)
Sure it did. Strange you offered none of the proof you asked me for. You can't even see what it made in that vid....but it wasn't 494.
Build it...show the detes. My bet is it was closer to 444....which would be really good for one of those turds.
Build it...show the detes. My bet is it was closer to 444....which would be really good for one of those turds.
#8782
Still going on Dyno this week?
#8783
10 Second Club
iTrader: (8)
Yup sure am as far as I know. Hopefully all goes well and it picks up a little. Realistically this is more just to run it to higher rpm because we had to stop before.
Last edited by HioSSilver; 08-14-2024 at 05:26 PM.
#8784
#8785
10 Second Club
iTrader: (8)
Made 546-548whp on several runs....got a couple of the dips out of it for better average power. Ran it to 7600 on the dyno and it basically stays flat. Not bad for a mild 5.7 and a plastic intake.
One of the most important things is it now idles with the ac on instead if acting funky.
Was a rough day....starter when out on the dyno which kept me from testing a little more due to the repair. Some of the things we tried just didn't seem like it did anything for it. Jeremy had a ctsv on the dyno when I showed up. He said it made less power on Friday than it did on Thursday......seemed kinda muggy. It is what it is and that's the number it made. I was hoping for 550whp just because it's a nice round number. It pulls pretty good.
One of the most important things is it now idles with the ac on instead if acting funky.
Was a rough day....starter when out on the dyno which kept me from testing a little more due to the repair. Some of the things we tried just didn't seem like it did anything for it. Jeremy had a ctsv on the dyno when I showed up. He said it made less power on Friday than it did on Thursday......seemed kinda muggy. It is what it is and that's the number it made. I was hoping for 550whp just because it's a nice round number. It pulls pretty good.
#8786
Made 546-548whp on several runs....got a couple of the dips out of it for better average power. Ran it to 7600 on the dyno and it basically stays flat. Not bad for a mild 5.7 and a plastic intake.
One of the most important things is it now idles with the ac on instead if acting funky.
Was a rough day....starter when out on the dyno which kept me from testing a little more due to the repair. Some of the things we tried just didn't seem like it did anything for it. Jeremy had a ctsv on the dyno when I showed up. He said it made less power on Friday than it did on Thursday......seemed kinda muggy. It is what it is and that's the number it made. I was hoping for 550whp just because it's a nice round number. It pulls pretty good.
One of the most important things is it now idles with the ac on instead if acting funky.
Was a rough day....starter when out on the dyno which kept me from testing a little more due to the repair. Some of the things we tried just didn't seem like it did anything for it. Jeremy had a ctsv on the dyno when I showed up. He said it made less power on Friday than it did on Thursday......seemed kinda muggy. It is what it is and that's the number it made. I was hoping for 550whp just because it's a nice round number. It pulls pretty good.
Let’s see a graph.
The following users liked this post:
HioSSilver (08-19-2024)
#8788
#8789
Teching In
The following users liked this post:
HioSSilver (08-19-2024)
The following users liked this post:
LSux (08-18-2024)
#8791
#8792
10 Second Club
iTrader: (8)
But hey did you 2 morons turn your pe tables off? Since a af of 14:1+ don't hurt anything and actually helps power according to your boi I figure yall be all over dat ****
Because he thinks a 4.sux is great
it sucks when you're trying to drive it and it does stupid ****.
#8794
#8796
#8797
Teching In
The following users liked this post:
HioSSilver (08-20-2024)
#8800