FS: NIB 408 Rotaing Assembly and 6.0 block
02-23-2010, 05:41 PM
#1
TECH Resident
Thread Starter
iTrader: (23)
Join Date: Aug 2005
Location: DFW, Texas
Posts: 750
Likes: 0
Received 0 Likes
on
0 Posts
FS: NIB 408 Rotaing Assembly and 6.0 block Bought this to build a turbo setup for my car, and now I have sold my car.
All parts are brand new in the box, have only been opened for inspection.
Rotating assembly:
Mahle 4.030 -32cc Inverted Dish Pistons w/new rings
Manley H Beam Rods
Livernois 4.00" Stroke Crank (they say it's Callies)
Federal Mogul Comp Bearings
It was this kit with a few changes. (was over $2200 new)
http://www.livernoismotorsports.com/...ing+Assemblies
6.0 Block bored .010 over with ARP Main Studs. Block is very clean and includes main caps. (Just stating the obvious:the block will have to be bored to .030 for the 408).
1900 FOR EVERYTHING PICKED UP
All parts are brand new in the box, have only been opened for inspection.
Rotating assembly:
Mahle 4.030 -32cc Inverted Dish Pistons w/new rings
Manley H Beam Rods
Livernois 4.00" Stroke Crank (they say it's Callies)
Federal Mogul Comp Bearings
It was this kit with a few changes. (was over $2200 new)
http://www.livernoismotorsports.com/...ing+Assemblies
6.0 Block bored .010 over with ARP Main Studs. Block is very clean and includes main caps. (Just stating the obvious:the block will have to be bored to .030 for the 408).
1900 FOR EVERYTHING PICKED UP
Last edited by slowredz; 02-24-2010 at 12:19 AM.
