1969 Chevy C10 Shortbed Pro Street/ Tubbed/ 5.3/ TH400
01-22-2009, 10:46 PM
#1
1969 Chevy C10 Shortbed Pro Street/ Tubbed/ 5.3/ TH400 69 C-10 Shortbed from California, Pro streeted in '99, brought here to Iowa/ Illinois border 3-4 years ago.
Swap and all new stuff has less than 500 miles on it
80k mile 5.3, stock - car intake
2.5" dual exhaust with flowmasters- sounds great
Fuel injection works great, fans controlled by PCM etc, get in and drive!
Fresh TH400, 2000 stall
Ladder bar/ coilover suspension.
Front disc brakes
15x14 rear wheels with 31 x 18.50 tires
Body is real decent, however the current paint is horrible-4 out of 10. I can see evidence of inner rockers being replaced, but there is no carpet and the floors are great, underneath is pretty nice. The bed is very nice with no evidence of repair ever. Overall a very solid truck.
Engine and drivetrain is great, starts right up, runs fine, sounds good
What this truck needs:
Interior :
- Carpet
- Steering wheel
- Better seat (bench would be great) and seat belts
- Dash pad
- Dash cluster has issues, printed circuit is in poor shape - replacements are available
The interior would be great with those items taken care of
Exterior :
- Paint Job...sucks
- Hood, 4" cowl is in pretty poor shape and is pin on, a new bolt on cowl would be great
Suspension :
- Front springs are cut....should have drop spindles and good springs for a better ride
- Rear spring rate is wrong, someone guessed at it so it rides rough
Misc:
- No heater, I cleaned up the firewall, best bet would be to buy underdash unit from Flex-a-lite, they are small, affordable, clean looking and work well
- Tires.......are shot...and old bias ply anyway....needs new Pro Stret Radials
Truck is located on Iowa/ Illinois border. I have driven it around and its pretty fun and attention getting. With some work it could be a high dollar piece, and the hard drivetrain EFI stuff is all done.
Price is $8000
Got an offer?....shoot.....got a trade under $3k plus cash....lemme know I might consider it
MeanYellowZ@hotmail.com
Swap and all new stuff has less than 500 miles on it
80k mile 5.3, stock - car intake
2.5" dual exhaust with flowmasters- sounds great
Fuel injection works great, fans controlled by PCM etc, get in and drive!
Fresh TH400, 2000 stall
Ladder bar/ coilover suspension.
Front disc brakes
15x14 rear wheels with 31 x 18.50 tires
Body is real decent, however the current paint is horrible-4 out of 10. I can see evidence of inner rockers being replaced, but there is no carpet and the floors are great, underneath is pretty nice. The bed is very nice with no evidence of repair ever. Overall a very solid truck.
Engine and drivetrain is great, starts right up, runs fine, sounds good
What this truck needs:
Interior :
- Carpet
- Steering wheel
- Better seat (bench would be great) and seat belts
- Dash pad
- Dash cluster has issues, printed circuit is in poor shape - replacements are available
The interior would be great with those items taken care of
Exterior :
- Paint Job...sucks
- Hood, 4" cowl is in pretty poor shape and is pin on, a new bolt on cowl would be great
Suspension :
- Front springs are cut....should have drop spindles and good springs for a better ride
- Rear spring rate is wrong, someone guessed at it so it rides rough
Misc:
- No heater, I cleaned up the firewall, best bet would be to buy underdash unit from Flex-a-lite, they are small, affordable, clean looking and work well
- Tires.......are shot...and old bias ply anyway....needs new Pro Stret Radials
Truck is located on Iowa/ Illinois border. I have driven it around and its pretty fun and attention getting. With some work it could be a high dollar piece, and the hard drivetrain EFI stuff is all done.
Price is $8000
Got an offer?....shoot.....got a trade under $3k plus cash....lemme know I might consider it
MeanYellowZ@hotmail.com
Last edited by MeanYellowZ; 06-10-2015 at 05:35 PM.
