Is this a 3 channel or 4 channel rear? Pics inside...
06-14-2008, 02:04 AM
#1
TECH Fanatic
Thread Starter
iTrader: (35)
Join Date: Aug 2004
Location: Paramount CA
Posts: 1,016
Likes: 0
Received 0 Likes
on
0 Posts
Is this a 3 channel or 4 channel rear? Pics inside... https://ls1tech.com/forums/showthrea...41#post9553441
Any idea if this rear is a 3 channel or a 4 channel?
Any idea if this rear is a 3 channel or a 4 channel?
06-14-2008, 02:30 AM
#3
TECH Fanatic
Thread Starter
iTrader: (35)
Join Date: Aug 2004
Location: Paramount CA
Posts: 1,016
Likes: 0
Received 0 Likes
on
0 Posts
I was thinking it was a four channel based on the fact that I couldn't see any type of a reluctor on the center of the differential. However there appears to be two reluctor rings on each axle so I'm guessing that makes it a 4 channel....
Revelation Z28 how did you determine it was a 4 channel?
Revelation Z28 how did you determine it was a 4 channel?
06-14-2008, 02:32 AM
#4
TECH Veteran
iTrader: (10)
Join Date: Jul 2006
Location: Rialto CA
Posts: 4,770
Likes: 0
Received 0 Likes
on
0 Posts
the blue wire connectors next to the backing plates, and the lack of the hole on the top of the housing. a 3 channel will have one connector at the top and just backing plates at the ends.
basically what you just said
basically what you just said
06-14-2008, 02:47 AM
#5
TECH Fanatic
Thread Starter
iTrader: (35)
Join Date: Aug 2004
Location: Paramount CA
Posts: 1,016
Likes: 0
Received 0 Likes
on
0 Posts
Any idea how to prep this thing? I sure as hell don't want to spend 2-4 hours sanding this bitch down.... and I don't want to paint over the rust and have it flake everywhere...
Any Ideas?
Any Ideas?
