Ravenous T\A

iTrader: (12)

Set-Up is
Harris Speed Nitrous/Fuel Solenoids, Dyno Tune Purge Solenoid, Cold Fusion Nitrous Spray Plate, Harris Custom Braided Lines, Harris Progressive MicroEdge+ Controller, Dyno Tune HiFlow Valve in a Nitrous Works 10lb Bottle, Dyno Tune N20 Filter, Nitro Dave's Automatic Bottle Heater, Nitrous Express 3 Switch Setup, AEM UEGO A/F Gauge. Autometer N20 Pressure Gauge mounted in a Anvil Auto Side Pillar Gauge

ZONES89RS

iTrader: (25)

Time to hit the track son!

RATBOX

iTrader: (26)

I was spraying a 175 shot on one of my bolt on Foxes last summer with one of those junk brand new HSW kits, not ******* impressed. By the second bottle the purge solenoid and N2o solenoid were freezing up. Guess I was glad it wasn't a fuel solenoid failing, or I'd have been out a motor. Only thing worth a **** they have is their switch panels. Just an FYI, good luck. Speed Tech, is good stuff, though.

Ravenous T\A

iTrader: (12)

Well right now I gotta figure a wayout to make a Aircleaner, I have some ideas but gotta see if its gonna work, all I need now is some trash to get sucked up in the motor so she is a garage queen until I get this figured out

ZONES89RS

iTrader: (25)

Dont worry about that BS at the track, just the street.

Ravenous T\A

iTrader: (12)

LOL, I know, but I gotta drive it for 30 min on the street to get to a track (which has a some dirt driveways)

ZONES89RS

iTrader: (25)

NEvermind then, LOL. I trailer my cars, just in case something brakes.

You do have me wanting to paint my intake black...

Ravenous T\A

iTrader: (12)

yea kinda gives it a plastic intake look