71 Chevelle+LY6+T56,
09-17-2012, 11:43 PM
#161
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
The fuel system is almost done, I couldnt use the brackets that came with the Walbro pump, they just wouldn't fit in the rear frame rail, so it's zip tied for now.
10-05-2012, 10:13 AM
#163
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
Vintage air kit came in, I'll be putting it in this weekend
Finally made a wheel choice, I prefer billets but they are not in the budget to make it to power tour next yr. enjoy
Finally made a wheel choice, I prefer billets but they are not in the budget to make it to power tour next yr. enjoy
10-06-2012, 09:43 AM
#164
On The Tree
Join Date: Nov 2011
Location: South east Wisconsin
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Those rims are going to look good! I hear ya with the hand bending brake lines, its tough to get them to look good.
In the picture you can kind of see my "handy" bent lines!
In the picture you can kind of see my "handy" bent lines!
10-11-2012, 08:42 PM
#167
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
Thanks to my buddy thebull for hookin me up with new rotors and calipers !! I packed new bearings and got them installed today after work.
I waited 4 days for a special tool from American auto wire.. But now progress!!
I waited 4 days for a special tool from American auto wire.. But now progress!!
10-24-2012, 06:46 AM
#171
Staging Lane
Join Date: Dec 2007
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
Any Pics or updates on the vintage air install? Interested in seeing how you mounted your box and where you routed your lines? Are you going straight through the firewall or you going to pop out more toward the fender and go under the fender (above the inner fender). I am at this point and struggling to make a decision.
10-24-2012, 11:31 AM
#172
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
I bought the fender kit to run my hoses thru the passenger vent inside the fender. No updates of the install, I'm still looking at options other than drilling holes in my firewall to mount the box.
Here are some pics I found that are similar to my install.
Here are some pics I found that are similar to my install.
10-29-2012, 05:15 PM
#176
What brand spark plug wires are those? I need to get a set also to fit my headers. A heads up on the AC, leave plenty of slack in your air duct hoses. My center dash hose is just about to fall off because I pulled the hose tight when I measured it and cut it.
10-29-2012, 05:55 PM
#177
