GhostofKrypton

iTrader: (7)

not really the fuse box, but that is next on my list. Rewired my pcm and tucked it inside and ran my wires like the wire mod, under the fender.

y2k_ta

iTrader: (80)

This is temporary. I am going to fab up a more secure bracket to mount the pcm to the car. The fuse block is to the left and behind the pcm (not shown in photo).

MrElectric03

iTrader: (71)

Nice, I like it.

XpEdItIoUs

iTrader: (44)

I have mine mounted inside where my hvac was



It cleaned up my engine bay

MUSTANGBRKR02

iTrader: (91)

Anyone finish theirs? I am starting mine now.

studderin

iTrader: (28)

I only have 1/2 the wires now that I went thu everything and depined unused stuff. I have a box full of wire, and a bog full of the old tape and loom. Put the PCM, 2step, and underhood fues inside the dash. Not all done yet, it looks a lot beter.

I wouldn't just put the fuses in that hole, so there end the front wheel well plastics. Ive done some swap cars were we did that. And ended up having alot of problems form them getting rusted mounted upside down. They were not form getting wet driving the car in the rain or anything, just form being mounted inside down. The littlest bit to moister dose a lot of damage.

XpEdItIoUs

iTrader: (44)

I got rid of the stock wiring and made my own on the hvac delete plate located inside the car, Here is some pics.

MrElectric03

iTrader: (71)

Damn dude that looks sweet! Where did you get the fuse block(standard sized fuses)?

XpEdItIoUs

iTrader: (44)

I got all the stuff from an electronics store. I spend over $100 in parts. You can get the fuse blocks in ATM and ATC.