valve springs for boost.
#1
valve springs for boost.
I seen in the sticky that patiot duals could be used but was wondering what everyone else uses. It will be stock bottom, stock cam, 317's and a D1sc with fmic set on 8# pulleys(I know, disaster waiting to happen). What are you guys with similar setups using?
#5
dont know how much truth there is to this statement, but i have been told by some locals that a set of stock springs on 241 heads will start to let loose after 7-8 lbs.....? like i said, dont know how much truth there is to this.
#7
Very true probibly start floating earlier like 5-6 lbs.
Trending Topics
#9
#11
#13
I'm going to go with at least patriot dual gold's to be safe. I also heard that prochargers 8 psi pullies actually make about 10-11 psi. Any thoughts?
#14
#15
That lift isnt too bad on that cam. You must be beatin the **** outta that thing to be blowin thru springs like that.
#17
a buddy of mine has this set up with stock springs, 241 heads, around 8 pounds i think, he hasn't had any problems been with the set up for over a year now
#20
haha yeah... I'm going to try and keep it at 8 until I can forge the bottom end... I can get a replacement for cheap but don't care to pull an engine if I don't have too....