TARZAN

iTrader: (12)

I am trying to get a downpipe made for my GT45, and the shop asked that I provide the v-band flange. Its a 1.05 ar I believe.....any help is appreciated.


-Will

TARZAN

iTrader: (12)

Or can anybody point me towards a sponsor to contact? I need this DP made.

Thanks,

-Will

dredoggy

iTrader: (2)

i had the same problem i have the gt-67 and played hell trying to find the right v-band i called sts and there sending me a 3.75" clamp and i measured 4" outer ring to outer ring so i assume it is for yours .25 of an inch less than what yours is . hope that helps

deadmanTA

iTrader: (7)

I couldn't find a V for my MP. Outside diameter of the cast-on flange was exactly 4" so I bought a 4" assembly and welded it on. 4" DP eventually reduces to a 3" pipe.

LS1NOVA

iTrader: (12)

Is this the oddball size one? Master Power GT45 right? Forced Inductions has them.

Hennytime

iTrader: (33)

isn't the mp gt45 like 850 bucks? why not just get a t76 for 1000

DrTurbo

iTrader: (3)

Correct, the TC 76 is a better turbo, more power, spools faster...etc..etc.


Also we no longer carry the clamp/flange assembly for the MP GT45. PITA to get....

BigJls1

These guys are not a sponser....Since no sponser that has them has chimed in. I will post.
they might have them, CALL
http://www.dynamicturbo.com/products...turbochargers/

TARZAN

iTrader: (12)

Henny and Drturbo,

There is always something better. Thats not what I asked about. I got a GT45 for less than $500, so I figure its worth a shot.

Big J,

Thanks for contributing something useful to the thread

-Will