LS1 Sheetmetal Intake $600
09-24-2008, 12:41 PM
#1
LS1 Sheetmetal Intake $600 Clearing out my garage.
I still have my sheetmetal intake from my old H/C setup.
Intake was built by behindbarsracecars about 5 years ago. I ran it on my car for a couple years.
It is set up for a stock size throttle body (this was back before the days of FAST or any other 90mm). A fabrication shop could likely modify it for a larger TB.
In includes a set of billet fuel rails that are mounted to it. It has provision in the rear for the MAP sensor and a port for the brake booster.
I never dyno'd with it on the car, but it made a huge difference (especially up top) over my LS1 intake setup.
I daily drove with this intake. Because of this, and my smaller 224/228 112lsa cam, the extra vacume/street made the top of the intake dip in a little. It doesn't effect performance.
I would like cash, but would consider full or partial trades for bolt ons (LS6 intake, long tube headers, etc) for the stock 98 TA i just purchased to daily drive.
I still have my sheetmetal intake from my old H/C setup.
Intake was built by behindbarsracecars about 5 years ago. I ran it on my car for a couple years.
It is set up for a stock size throttle body (this was back before the days of FAST or any other 90mm). A fabrication shop could likely modify it for a larger TB.
In includes a set of billet fuel rails that are mounted to it. It has provision in the rear for the MAP sensor and a port for the brake booster.
I never dyno'd with it on the car, but it made a huge difference (especially up top) over my LS1 intake setup.
I daily drove with this intake. Because of this, and my smaller 224/228 112lsa cam, the extra vacume/street made the top of the intake dip in a little. It doesn't effect performance.
I would like cash, but would consider full or partial trades for bolt ons (LS6 intake, long tube headers, etc) for the stock 98 TA i just purchased to daily drive.
Trending Topics
09-24-2008, 10:24 PM
#19
Sale is pending on this guys. I went with the first person who said they would indeed take it. His offer was an LS6 intake, ported TB, aftermarket lid, and $200. If it falls thru i will let you guys know its back up for sale.
Here are the pics that i took. Its been sitting in my garage for a while, so it needs cleaned up a little bit. I just wiped it down with a wet rag to get the dust off it.
Here are the pics that i took. Its been sitting in my garage for a while, so it needs cleaned up a little bit. I just wiped it down with a wet rag to get the dust off it.
