LS1 Lid + LS1 rad support + stock hood = DONE
#1
LS1 Lid + LS1 rad support + stock hood = DONE
EDIT: writeup here http://joelrdevriendt.com/?p=46
sheet metal wasnt my thing, i think this looks nicer excuse the filthy engine bay
sheet metal wasnt my thing, i think this looks nicer excuse the filthy engine bay
Last edited by JoeliusZ28; 08-31-2010 at 03:14 PM.
#4
i did the lid install the same way everyone else has done it, then just modified the LS1 radiator support to fit it. I had to trim a LOT of plastic off it. There is probably only 50% of it left lol. My idea was to just set the lid down inside the shroud instead of on top of it and this is what i got. the support is set back a few inches from where it would normally be, i used self tapping screws to secure it. Its VERY solid, i couldnt be happier with it.
I have more pictures i can post if people want, but im headed out the door right now.
I have more pictures i can post if people want, but im headed out the door right now.
Trending Topics
#8
I will take it back apart and get some detailed pictures tomorrow.
Im gonna say right now though it was a lot of work, but alot of it was trial and error. I spent way more time on the radiator support than i did fabricating the lid.
Im gonna say right now though it was a lot of work, but alot of it was trial and error. I spent way more time on the radiator support than i did fabricating the lid.