yak

iTrader: (15)

I just swappped a 6 speed in my car. right now I am on 3.42 gears and the car bucks real hard below 2500rpm. How do I stop the bucking? I have never driven a car with a big clutch in it (spec stg 3). I don't really want to ride the clutch at low speeds. 4.10s are going in tonight hopefully they will help, but does anyone have any advise?

ls1muscle

iTrader: (16)

EFILive

brad8266

iTrader: (23)

tuning and gears

yak

iTrader: (15)

anything I can do before the tune?

93camaro_zzz

iTrader: (13)

Mine does it, you just have to kinda lean how to drive it. Mine wont buck anymore, because I am a good driver.

yak

iTrader: (15)

haha, care to share a few points of your good driving?

98TA Bandit

iTrader: (2)

Same here it sucks, but my 3.90 made a big difference just ride the clutch out.

slick1851

Just get that **** tuned and be done with it

theroad64

iTrader: (1)

My RX7 bucks with the HotCam below 2500..and its got 4.10s. Is untuned as of yet.

SSTYCOON

iTrader: (2)

If you let the clutch out real shitty, it'll buck. Let it out nice when your slow rolling. Tuning is an issue too.

Phillymu

iTrader: (3)

All in the tuning

My MS4 doesn't buck at all untill it is around 1100 RPM

Gears will help also

coolformula

iTrader: (21)

Just takes practice. I"m in the same boat. .605 lift cam. Stock rear and just put in a new clutch. Just have to give it another gas. My tune is pretty good. Just go out and practice more. Thats what I have been doing.

N4cer

iTrader: (11)

Tuning. Gears.
And when the bucking starts, the natural reaction is to let out of the gas. Don't. Mine stops if I lay into it instead.