I have one of your ashtray switch panels, and the lights always stay on no matter if the switch is tricked or not I'd rather the lights come on when i flip the switches, it would make things much easier to me. any help would be great, Thanks

 

How do you have it wired? Are you sure the pins are going to the right post? Easiest way to get support is here: http://www.harrisspeedworks.com/support/

We can attach diagrams and a bunch of other documents a lot quicker than via a chat forum. Thanks.

Nick

 

I can take pics during lunch. I tried changing the wires around on the posts but it didn't work. I'll get on there or email you some pics

 

Sounds good! Thanks.

Nick

 

I've tried switching the wires around but they lights on the switches always stay lit.
Red= power
Black= ground
colors correspond to component
only using nitrous, purge, and acc.2 switches. acc1 is disconnected.

 

a is your switched 12v
b is your acc
c is your ground

 

 

Ok, are your a/b/c corresponding to how they are in my pic top to bottom? keep in mind the switches are upside down in that pic

 

the prings should have a abc or 123

 

kthx.

I'll go try in a minute

 

Looking at the instructions compared to your picture, switch the 1 & 2 around. IE it looks like you have the acc. wire hooked up to where the 12+ wire should go. Let me know what you come up with. I'll try and check up here when I get home after dinner. Thanks.

Nick

 

Yeah they are fine now. They worked before just the light was on all the time. I probably should have read the instructions lol. At least now it's how I wanted it. thanks bad6as and nick

 

No problem! Let me know if you stumble across any more issues. Thanks!

Nick

 

Great product btw

 

Thanks!

Nick

 

The way I have It wired is Acc2 turns on my water pump+ fan, Nitrous arms WOT and turns on dedicated race tank pump. Heater and acc1 are free for expansion.