SOLD 10 sec engine
02-23-2011, 08:40 PM
#1
10 Second Club
Thread Starter
iTrader: (126)
Join Date: Sep 2004
Location: TAMPA
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
SOLD 10 sec engine Category: Engine - Complete Motors
Price: $1
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird
Location (State): CT
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9
LS Engine?: Non-LS Part
Gen IV 6.0 steel block .005 over (2007)
New stock crank 58x
SFI harmonic balancer with ARP bolt
New Eagle 6.125 h beam rods with 8740 bolts
New Custom Wiesco 3cc dome pistons
New Blueprinted LS6 oil pump
New Pat G custom Cam
New LS2 timing chain set
New Morel hyd lifters
New Comp cam hardened pushrods
LS6 valley cover
Stock valve covers with New coils and wires
AFR 225 Heads totally gone through and milled to 62cc with New Patriot extreme double springs with tit. retainers. Yields just a under 12 to 1.
ARP main studs and head bolts
All New Rings and bearings. Durabond,King,Clevite, Sealed Power file fit rings
Street and Performance custom 1st gen oil pan
Mez. electric race water pump
Nascar 1 wire 100+ amp alternator on custom bracket
SFI flexplate
Edelbrock Vic Jr carb intake
Nitrous Express GEMINI TWIN STAGE 6 Plate system. Good up to 300hp (no bottle or line inc.)
Prosystems custom carb speced for this engine
This is a true 93 octane pump gas engine. No BS. I built it so that you can drive it anywhere and buy gas at any gas station. Went to the track twice this past season.
Runs 11.1-11.3@ 120-121 on motor 93 octane.
Ran 10.01 @140 on a 200hp shot with 116 race fuel. See link to vid in my sig.
This engine has a total of 11 engine passes and the 1 nitrous pass in my sig. Plus no more then 500 street miles.
This engine was built and professionaly balanced and blueprinted by Kehl Tech here in CT. They have built many LS motors for Eastside Performance. Kehl Tech also Dyno tuned this engine on their in house engine dyno. After the engine was installed, it was professionally tuned again on a chassis dyno at Otto's Performance on motor and nitrous.
I'm only willing to seperate if someone buys the complete shortblock first.
I have over $11k in this engine.
Looking for $7900 Complete Carb to Pan. Plus shipping. obo
Please PM all offers.
Last edited by GONEB4U; 03-17-2011 at 08:25 PM.
