B&M Hammer install pics
Thread Starter
8 Second Club
iTrader: (34)
Joined: Nov 2001
Posts: 10,852
Likes: 1
From: Knoxville, TN
B&M Hammer install pics Didnt finish putting the cable on but here is a few pics of a B&M Hammer I installed tonight. I have seen a couple other pics but figured it may help someone out..
I just roughly traced the shift boot onto a piece of 1/8" aluminum plate I had laying around, cut it with a jigsaw and bolted it down. Massaged the the ends with a hammer and there is very little gap, nothing a little silicone from underneath cant handle. Had to space up the rear quie a bit and trim off the mounting tabs for the plastic cover that comes with the shifter (see pics). Looks pretty nice and seems to work well - i'll find out when I get the TH350 in..
I just roughly traced the shift boot onto a piece of 1/8" aluminum plate I had laying around, cut it with a jigsaw and bolted it down. Massaged the the ends with a hammer and there is very little gap, nothing a little silicone from underneath cant handle. Had to space up the rear quie a bit and trim off the mounting tabs for the plastic cover that comes with the shifter (see pics). Looks pretty nice and seems to work well - i'll find out when I get the TH350 in..
Thread Starter
8 Second Club
iTrader: (34)
Joined: Nov 2001
Posts: 10,852
Likes: 1
From: Knoxville, TN
The shifter works for powerglides and 4 speed autos so yes it will work with a 4L60.
The tabs that were cut were to mount the little plastic console B&M gives you. The boot wont sit flush in the front if you dont cut the front one and the ashtray wont open if you dont cut the rear one. Maybe if it was mounted a little different you wouldnt have to cut them but they really serve no purpose for this application..
The tabs that were cut were to mount the little plastic console B&M gives you. The boot wont sit flush in the front if you dont cut the front one and the ashtray wont open if you dont cut the rear one. Maybe if it was mounted a little different you wouldnt have to cut them but they really serve no purpose for this application..
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Thread Starter
8 Second Club
iTrader: (34)
Joined: Nov 2001
Posts: 10,852
Likes: 1
From: Knoxville, TN
Originally Posted by DOC OTIS
Great info. Thanks for the pics. Getting ready to do the same install. Except I am going to modify the stock M6 shifter handle instead of using the t-handle.
