jimmyg

Need to mount a small meth tank and pump in the truck of my 83 cutty. Any body have a similar set up? I just don't want to drill a bunch of holes in the trunk. Need to fig out some kind of bracket set up. Ideas?

svslow

Do you have a picture of your trunk?

jimmyg

I can post one prob tonight.

svslow

Something like this an option?

http://i107.photobucket.com/albums/m...00510-1356.jpg

3 window

iTrader: (1)

I put a bend in a piece of 16 ga steel and mounted my tank and pump to it. All wiring is behind through a weatherpack connector. It's a 3 quart tank. Two holes is all into the trunk floor.
​​​​​​​

jimmyg

Yes that looks perfect. That is the same set up I'm using .Is that free standing? Just mounted to the trunk? Did you buy the solinoid?

jimmyg

No . Old school trunks don't have all the panels like the newer stuff.


Looks like this, but a battery box mounted in center of shelf.

truckdoug

iTrader: (25)

fab a little bracket and use the 2.5 gallon agrimart tank and put it in the spare tire well

3 window

iTrader: (1)

Yah, it's free standing. The 16 ga is pretty thick. I'm not using the solenoid, but I also haven't run the kit yet either. My car's currently on E85. I'll be running it once I switch to a lesser ethanol content fuel.

stevieturbo

Alcohol Injection Systems makes some nice tanks ( now called ProMeth )

lower_the_dynamite

iTrader: (22)

I found this 2 gallon tank and breathable cap at US Plastics website under $35.00. They have a lot to choose from and the design docs available for all specs. I'll post the link here but it might be removed by an admin. Good luck!

https://www.usplastic.com/catalog/it...4163&catid=578

ls1curt

iTrader: (31)

fbody one i'm working on. The pump is mounted to the inner fender. And my notch.