Putting new heads need advice
11-01-2017, 01:27 AM
#1
Teching In
Thread Starter
Join Date: Dec 2011
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Putting new heads need advice I am doing heads on my ls1 and want to know what head gasket to use and push rod.heads are 241 prc cut down to .30 and cam is a ms3 will I have to check valve clearance or I'll be good.thanks
11-01-2017, 01:33 AM
#2
TECH Senior Member
Do you mean milled .030"?
Cut down to .30 means nothing.
Cut down to .30 means nothing.
11-01-2017, 02:21 PM
#6
TECH Apprentice
iTrader: (3)
Join Date: Oct 2014
Location: Dyers Eve, NW Indiana
Posts: 313
Likes: 0
Received 0 Likes
on
0 Posts
Very unlikely this combo will provide acceptable ptv measurements. Even with stock unmilled heads, the MS3'S PTV has only been described as adequate.