Street Racing & Kill Stories Basic Technical Questions & Advice

Epic SRK B/S thread of 2019

Thread Tools
 
Search this Thread
 
Old 07-12-2020, 10:34 AM
  #7241  
TECH Apprentice
 
CamOnlyJabroni's Avatar
 
Join Date: Sep 2014
Location: Fort Wayne, IN
Posts: 321
Received 88 Likes on 62 Posts
Default

Originally Posted by ohioborn80
I was seeing intake temps of 147-152 at end of runs, i start pulling timing at 140. Should see 21-22 degrees, i was seeing 16-17

I need interchiller
If it’s running E85 I would alter in the tune where the ecm actually pulls timing because of IAT temps. Just raise the ceiling then check for knock.

it all comes down to EGT’s. Combustion temps on E85 with IATs in the 150’s is going to be lower than combustion temps on 93 with IATs in the 150’s.

Last edited by CamOnlyJabroni; 07-12-2020 at 10:52 AM.
Old 07-12-2020, 01:02 PM
  #7242  
10 Second Club
iTrader: (2)
 
ohioborn80's Avatar
 
Join Date: Aug 2009
Location: Texas
Posts: 214
Received 252 Likes on 164 Posts

Default

Originally Posted by islander033
Looks like I got you beat from Friday BC.

I was just running 1/8 and hitting the brakes to try and keep from getting booted. DA was around 4000ft.


nice, i wish i could of got a 60ft like that. Leaving in second it still spun hard as ****. Lol
Old 07-12-2020, 02:03 PM
  #7243  
7 Second Club
 
islander033's Avatar
 
Join Date: Jul 2013
Location: Crossfield, AB
Posts: 239
Received 313 Likes on 242 Posts

Default

Originally Posted by ohioborn80
nice, i wish i could of got a 60ft like that. Leaving in second it still spun hard as ****. Lol
Too many torks!
The following users liked this post:
NW-99SS (07-13-2020)
Old 07-13-2020, 08:17 AM
  #7244  
TECH Fanatic
iTrader: (6)
 
NW-99SS's Avatar
 
Join Date: Aug 2007
Location: AB, Canada
Posts: 1,136
Received 171 Likes on 119 Posts

Default

Originally Posted by islander033
Looks like I got you beat from Friday BC.

I was just running 1/8 and hitting the brakes to try and keep from getting booted. DA was around 4000ft.


Full interior and A/C running too, damn!
Old 07-13-2020, 08:28 AM
  #7245  
7 Second Club
 
islander033's Avatar
 
Join Date: Jul 2013
Location: Crossfield, AB
Posts: 239
Received 313 Likes on 242 Posts

Default

Originally Posted by NW-99SS
Full interior and A/C running too, damn!
No, I was in my full race setup. 3805lbs with driver.
Old 07-13-2020, 08:47 AM
  #7246  
Banned
 
HpipeFlowmasterStang's Avatar
 
Join Date: Dec 2018
Location: Nebraska
Posts: 21
Received 27 Likes on 24 Posts
Default

Look at Hio’s comment... crying even on youtube videos lmao.. whats wrong Hio? Hate the fact that the Shelby took on the way lighter C7 zo6 FBO?

The following users liked this post:
islander033 (07-13-2020)
Old 07-13-2020, 09:19 AM
  #7247  
TECH Fanatic
iTrader: (6)
 
NW-99SS's Avatar
 
Join Date: Aug 2007
Location: AB, Canada
Posts: 1,136
Received 171 Likes on 119 Posts

Default

Originally Posted by islander033
No, I was in my full race setup. 3805lbs with driver.
Old 07-13-2020, 10:48 AM
  #7248  
10 Second Club
iTrader: (2)
 
ohioborn80's Avatar
 
Join Date: Aug 2009
Location: Texas
Posts: 214
Received 252 Likes on 164 Posts

Default

Originally Posted by HpipeFlowmasterStang
Look at Hio’s comment... crying even on youtube videos lmao.. whats wrong Hio? Hate the fact that the Shelby took on the way lighter C7 zo6 FBO?

https://youtu.be/IpR21xs-SYA
he seems butthurt on someone elses video, nothing new
Old 07-13-2020, 03:05 PM
  #7249  
Teching In
 
2003Cobro's Avatar
 
Join Date: Nov 2013
Location: Temecula, CA
Posts: 9
Received 12 Likes on 12 Posts
Default

Originally Posted by HpipeFlowmasterStang
Look at Hio’s comment... crying even on youtube videos lmao.. whats wrong Hio? Hate the fact that the Shelby took on the way lighter C7 zo6 FBO?

https://youtu.be/IpR21xs-SYA
bwahahaha what a sorry little baby.
Old 07-13-2020, 03:42 PM
  #7250  
10 Second Club
iTrader: (8)
 
HioSSilver's Avatar
 
Join Date: Aug 2002
Location: Winchester, VA
Posts: 5,936
Received 425 Likes on 336 Posts

Default

So yall really think a 11sec car can beat a fbo c7 z06????

btw fbo c7 zo06 has been 8s.....jus sayin

Seems like the dude with the green gt280 is a known bs'r. Figures yall would stand behind him. But yall stand with hblowmaster so
Old 07-13-2020, 04:16 PM
  #7251  
10 Second Club
iTrader: (2)
 
ohioborn80's Avatar
 
Join Date: Aug 2009
Location: Texas
Posts: 214
Received 252 Likes on 164 Posts

Default

Originally Posted by HioSSilver
So yall really think a 11sec car can beat a fbo c7 z06????

btw fbo c7 zo06 has been 8s.....jus sayin

Seems like the dude with the green gt280 is a known bs'r. Figures yall would stand behind him. But yall stand with hblowmaster so
11 sec car? Gt500 been mid 10s bone stock idiot. Several have done it now.

and that c7z could still be fbo, probably didn't have 15" conversion ported blower etc etc like the hero car your talking about.

Old 07-13-2020, 06:04 PM
  #7252  
TECH Apprentice
 
CamOnlyJabroni's Avatar
 
Join Date: Sep 2014
Location: Fort Wayne, IN
Posts: 321
Received 88 Likes on 62 Posts
Default

Poor C7Z’s just ain’t got it.
Old 07-13-2020, 07:01 PM
  #7253  
TECH Fanatic
iTrader: (1)
 
Jtm2085's Avatar
 
Join Date: Jun 2007
Posts: 1,219
Received 14 Likes on 13 Posts

Default


I'm putting this motor in the car for the second time now. The guy that built the bottom end the first time completely screwed me. After 4 dyno pulls the motor was knocking and the oil pan was filled with bearing material. One cylinder was so tight that it destroyed a piston in this short time. I almost want my SBE build back lol
The following users liked this post:
Nick.H (07-13-2020)
Old 07-13-2020, 07:21 PM
  #7254  
10 Second Club
iTrader: (8)
 
HioSSilver's Avatar
 
Join Date: Aug 2002
Location: Winchester, VA
Posts: 5,936
Received 425 Likes on 336 Posts

Default

Originally Posted by ohioborn80
11 sec car? Gt500 been mid 10s bone stock idiot. Several have done it now.

and that c7z could still be fbo, probably didn't have 15" conversion ported blower etc etc like the hero car your talking about.
Good point dipshit. The z06 and zl1 has both been 10s stock to. Thus confirming that something is up with that race.

Especially after the zl1 with bolt ons walked the gt500.


Originally Posted by Jtm2085

I'm putting this motor in the car for the second time now. The guy that built the bottom end the first time completely screwed me. After 4 dyno pulls the motor was knocking and the oil pan was filled with bearing material. One cylinder was so tight that it destroyed a piston in this short time. I almost want my SBE build back lol
lol....l know how you feel. My motor is fine but i really miss the easyness of the bolt on ls6.
Old 07-13-2020, 08:36 PM
  #7255  
10 Second Club
iTrader: (2)
 
ohioborn80's Avatar
 
Join Date: Aug 2009
Location: Texas
Posts: 214
Received 252 Likes on 164 Posts

Default

Originally Posted by HioSSilver
Good point dipshit. The z06 and zl1 has both been 10s stock to. Thus confirming that something is up with that race.

Especially after the zl1 with bolt ons walked the gt500.



lol....l know how you feel. My motor is fine but i really miss the easyness of the bolt on ls6.
what zl1 has been 10s stock? I must have missed that one.
and last seen gt500 trapped more than stock c7z06.

But the street is always the equalizer. Anything can happen
Old 07-13-2020, 08:40 PM
  #7256  
Banned
 
HpipeFlowmasterStang's Avatar
 
Join Date: Dec 2018
Location: Nebraska
Posts: 21
Received 27 Likes on 24 Posts
Default

LMAO @ Hio. Here he goes again! ‘Something wrong, shoulda, woulda, coulda LOL.

the C7 got walked by the beastly Shelby. Video proved it. End of discussion. Go shave some more pounds off your cars Mr. Hole Puncher. Thats the only modding that works for you Mr. 1,200 lb car lmao.
Old 07-13-2020, 10:01 PM
  #7257  
10 Second Club
iTrader: (8)
 
HioSSilver's Avatar
 
Join Date: Aug 2002
Location: Winchester, VA
Posts: 5,936
Received 425 Likes on 336 Posts

Default

Originally Posted by ohioborn80
what zl1 has been 10s stock? I must have missed that one.
and last seen gt500 trapped more than stock c7z06.

But the street is always the equalizer. Anything can happen
Gm has had cars capable of going 10s stock for nearly 15yrs now. Weird eehh.....and now all of a sudden you think it's awesome.

Originally Posted by HpipeFlowmasterStang
LMAO @ Hio. Here he goes again! ‘Something wrong, shoulda, woulda, coulda LOL.

the C7 got walked by the beastly Shelby. Video proved it. End of discussion. Go shave some more pounds off your cars Mr. Hole Puncher. Thats the only modding that works for you Mr. 1,200 lb car lmao.
you have no car. so I'm ahead of you.
Old 07-13-2020, 10:09 PM
  #7258  
Banned
 
HpipeFlowmasterStang's Avatar
 
Join Date: Dec 2018
Location: Nebraska
Posts: 21
Received 27 Likes on 24 Posts
Default

Originally Posted by HioSSilver
Gm has had cars capable of going 10s stock for nearly 15yrs now. Weird eehh.....and now all of a sudden you think it's awesome.


you have no car. so I'm ahead of you.
“capable” LMAO.. a Honda Civic is capable of going 9’s. Now all of a sudden you think thats awesome?

as far as my car. my 5.0 engine cover is heavier than your tin can car lmao
Old 07-13-2020, 10:46 PM
  #7259  
10 Second Club
iTrader: (2)
 
ohioborn80's Avatar
 
Join Date: Aug 2009
Location: Texas
Posts: 214
Received 252 Likes on 164 Posts

Default

Originally Posted by HioSSilver
Gm has had cars capable of going 10s stock for nearly 15yrs now. Weird eehh.....and now all of a sudden you think it's awesome.


you have no car. so I'm ahead of you.
everything is capable of something, but where is this zl1 going 10s stock? And proof its stock, we know how you are with fudging stuff

Last edited by ohioborn80; 07-13-2020 at 10:52 PM.
Old 07-13-2020, 10:50 PM
  #7260  
On The Tree
 
Nick.H's Avatar
 
Join Date: May 2013
Location: Dirty D, CA
Posts: 134
Received 14 Likes on 11 Posts

Default

Weird seeing Jake argue with Doug


Quick Reply: Epic SRK B/S thread of 2019



All times are GMT -5. The time now is 12:28 AM.