trying to install this bitch of a mastery cylinder. ticks adjustable. how the **** do you get the tick master cylinder in there. the steering rack is in the way and the brake master cylinder is in the way. i dont see how it could possibly fit in there. how do you go about putting it in? im about to blow my car up i cannot for the life of my get this ****** in there. so much **** is in the damn way. plz someone explain i have to drive this bitch to work tomorrow...

ive tried all ways think able. plz someone who has installed theirs, plz give me some kind of advice im about to blow up...

 

Well, it just takes some time and persuasion, i think you might be able to remove the brake booster to get it in pretty easy if i remember correct, it as been a long time for me so i am sure someone will be able to shed some more info on it.

 

If i remember correctly, you have to remove the "eye" and the cylinder can only go in one way.

 

well i had to remove some air thing thats connected to driver side header. and went in at some weird *** angle lol. its in just working on the rest thanks guys!

 

I was able to get it in there without removing anything exept the hose going to the brake booster, but i went back with regular bolts intead of that damn u-bolt. Good luck getting that ****** back in.

 

well it was def an adventure lol. when i bled the clutch, i just prebled the master, didnt even have to open the bleeder valve on the tranny thx again guys

 

i do master cylinders in 40 mins.

 

i did mine in about 5 minutes.... with the motor out..