mikespeed95

iTrader: (1)

Hey everyone,
I need a number/info on a big fastener place to get a 8x1.25 hex head bolt iwth a 45* tapered head to fit the valley cover on my ls1 so my blower can go back on. i was using harbor freight stuff and it broke off in it, then all i had left was my matco 6'' long bit..yah dead too.

heres what i need in case your wondering i need to know a place that has a bunch of fasteners so i can call find who has it and pick some up.

[img]this is what i need, its 8x1.25 and has a 45* tapered head with a 5mm hex in it, i need some big fastener place that will sell all kind fo stuff because they will probably have this and i can call adn find out and go snag it.


[/img]

please post contact info for the place!

00'blkss

iTrader: (13)

i dont know the name sof them but there is one off 290 and gesner on the left and one off jone a lil down from 1960 by the auto parts store sorry not much help

ZL1SS

iTrader: (4)

That pic is about as bad as they get!

mikespeed95

iTrader: (1)

i uploaded to imageshack and direct linked it, ill switch to a myspace pic later once i get home.

ls1 joe

iTrader: (37)

There is a place on Hemstead hwy called Turner hardware, they have a lot of weird fastners. They are on the corner of 34th and Hempstead hwy. They are also open on Sat until 12pm.

bigfatls6

iTrader: (34)

There is a place on the norht side located in the Greenspoint area off of aldine westfield. I can't think of the name of it but I will get it in the morning and post it up.

mikespeed95

iTrader: (1)

bump, heres a non huge pic.

95zpro

Ace hardware has a good selection of fasteners !!!

mikespeed95

iTrader: (1)

got it from a place in college station after calling aroudn everywhere and a bunch of dead ends.