Fireball Outlaw Drag Radial Rebuild Thread
#107
TECH Senior Member
Thread Starter
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
I didn't cut nearly as much as this guy
Last edited by Fireball; 10-26-2009 at 06:46 AM.
#115
TECH Senior Member
Thread Starter
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
should be able to get alot done this weekend...
I'm ordering the wing today from Kurt Urban (clear coated carbon fiber)...not cheap but should look bada$$
Unfortunately, it may take a while to get since Canadian time is unpredictable
I'm picking up a bunch of 1/2" chromemoly tubing to frame up the rear area I cut out and will be riveting down a thin sheet of fiberglass to seal it off...should be very light.
I've already got the main bar of the front bumper support bent, fit and tacked in place...didn't get a chance to finish since I ran out of Argon I hope to finish that up too this weekend so the turbo will be final mounted so I can take off the front fenders...
I'm ordering the wing today from Kurt Urban (clear coated carbon fiber)...not cheap but should look bada$$
Unfortunately, it may take a while to get since Canadian time is unpredictable
I'm picking up a bunch of 1/2" chromemoly tubing to frame up the rear area I cut out and will be riveting down a thin sheet of fiberglass to seal it off...should be very light.
I've already got the main bar of the front bumper support bent, fit and tacked in place...didn't get a chance to finish since I ran out of Argon I hope to finish that up too this weekend so the turbo will be final mounted so I can take off the front fenders...