luisdm

iTrader: (13)

I opend my oil cap on the engine and some white smoke was coming out. Not alot but enough to worry me. Is this bad or normal. Or are me rings going bad.

how hard is it to change the oil pan gasket, or should i just pay 300 bucks?

zamora7

iTrader: (4)

I think those are your piston rings going bad.

SparkyJJO

iTrader: (11)

Sure it wasn't just a little steam?

Reject

iTrader: (24)

vapor more than likely, my engine dose that too, sept i have a breather for the oil cap

slayerized6

iTrader: (12)

its just condensation burning off. its normal.

replacing the oil pan gasket has nothing to do with anything unless your leaking oil

shaun

my car does that i think its just hot oil vapor

Johnny-LT1-runner

iTrader: (15)

Sounds like steam or a lack of oil.

luisdm

iTrader: (13)

Ok I'll put a pic up just in case but yea it's more of a stream. And my
oil was low bc my pan gasket is leaking.
Thanks guys

01ssreda4

iTrader: (96)

Pan gaskets are about 50 bucks and are a pain in the *** to do bc you have to drop the k member about 6 to 12 inches.

SOMbitch

iTrader: (8)

Or loosen motor mounts and raise the motor. Lining the mounts back up can be a b!tch though.......

Just another option......

SparkyJJO

iTrader: (11)

I did the motor mounts method. That was fun.

fccs

iTrader: (26)

lol anyone sometime says "that was fun" on these forums, that means difficult in english ahah

01ssreda4

iTrader: (96)

I lifted my motor as high as it would go, i still couldnt get the pan to come out (trans was still there) then I dropped the k member about 2-3 inches. Still wouldnt come off. Once I got the k member 8 or so inches I was able to squeeze it out. The intake was on the cowl so the motor could go any higher.