Found a set of these headers for cheap and seen what the actual price is. I currently have kooks 1 7/8 and thinking about going to these. Mine are not in the vest shape and I have only read a couple of review on these people who have used them. well here the link what u think?

 

Link to headers I speak of.

http://store.edelbrock.com/victorser...echcoated.aspx

 

no idea but those are a hell of a good price is all i gota say lol

 

I'd be hesitant as they're a 1 3/4 header stepped to 1 7/8ths, unlike the full 1 /78ths you have now

 

Thats what I'm saying. They went on saker like this a while back. Might just say fit and order them now and try both out with the new set up.

 

https://ls1tech.com/forums/generation-iii-external-engine/1454163-edelbrock-stainless-headers.html


This is the thread I can find.

 

Well how bad are your kooks? These aren't stainless i dont think, and will eventually rust through the coating.

I would just keep your 1 7/8 stainless kooks.

 

Well I don't care for strainless. Just wrider headers will be better.

 

I just ordered a pair Monday.

 

Why did u decide to get them?

 

Good headers for a good *** price

 

Im just going to order them lol. ill try these and the kooks

 

hell i wish i had 200$ !!!!!

 

i think i'm going to order a set to keep... i have pacesetter 1 3/4" wonder how much of a "gain" if any???

 

I ordered mine last night for that same reason ^^ suppost to be good for low end torque. I guess my car will have everything new now....

 

I need ALL the low end torque i can get!LOL
they killed me on shipping!!!

 

how much shipping they charged u? mine was like 35 lol i was like holly ****!

 

Yea like $31 on shipping for me

 

Maryland speed dyno tested Kooks 1 7/8 and their stepped headers and got 10rwhp by going with stepped on B2B pulls. Searh my name for threads started and there is a link in my post in the Dyno section.

 

the edelbrock headers have 3.5 collectors