Speed Engineering Race Version Headers Now Available!!
#1181
Probably going to pick up a set of 1 7/8 this fall. Has the problem with the driver side collector angle been fixed? I have a set of 1 3/4 and had to do some serious modifications to my y pipe.
#1187
Yes, sir. We are finally coming out with a true dual dump and rear exit kit. Both have already been prototyped, sent back from the factory for test fitting, and ok'd. Our first batch of them should be around December or January. Both will be 3" systems.
Thanks
Sean
Thanks
Sean
#1190
Yes, sir. We are finally coming out with a true dual dump and rear exit kit. Both have already been prototyped, sent back from the factory for test fitting, and ok'd. Our first batch of them should be around December or January. Both will be 3" systems.
Thanks
Sean
Thanks
Sean
Awesome cant wait to order these
#1193
Finally got around to getting the 1 7/8 on my car the other day. I had the heads off too, with the heads off the passenger side will go in from the top and just sit out of the way. The drivers side won't go in from the top, so I put both heads on and got the engine back together.
The drivers side header was a breeze once I got the car up high enough. The only thing I had to remove was the steering shaft. Oil filter was still in place, and the header just slid up and into place.
Clearance is a little close to the k member on the drivers side, but I was lazy and didn't swap out my motor mounts. More than likely my fault. Great deal, great fitting headers. The only problem I have is the clamps are kinda not the right size at all, but this has been addressed already.
I will be looking into the true duals when they come out, and I'll also be buying some 1 3/4 long tubes for my 99 5.3 truck in the future.
Thanks again for the good work!
The drivers side header was a breeze once I got the car up high enough. The only thing I had to remove was the steering shaft. Oil filter was still in place, and the header just slid up and into place.
Clearance is a little close to the k member on the drivers side, but I was lazy and didn't swap out my motor mounts. More than likely my fault. Great deal, great fitting headers. The only problem I have is the clamps are kinda not the right size at all, but this has been addressed already.
I will be looking into the true duals when they come out, and I'll also be buying some 1 3/4 long tubes for my 99 5.3 truck in the future.
Thanks again for the good work!
#1197
jblankenship: Unfortunately, we wont know a price until production is complete.
superchargedZ: There should be a few install pics throughout the thread, and I believe a couple customer install threads by themselves.
Thanks
Sean
superchargedZ: There should be a few install pics throughout the thread, and I believe a couple customer install threads by themselves.
Thanks
Sean