Nah just a young kid who needed money and had something better.

my .685 lift springs showed up.

 

Ordered. Brake for this tci th350 I have.

 

What kinda plugs should a guy run in something like this? Br7ef?

 

Yes. A 7 plug is where I would start with 13.5 compression.

 

Well I was roughing in the last port last night night and then suddenly .......

luckily I was able to reach it with my tig and weld it up. Taking it to the machinest to be pressure tested today.

 

Oooooppss.....

 

Someone goin in deep!!

 

Maximum OOF.

Yeeep lol. Last damn runner too. She’ll be alright lol.

ordered new quarters and new wheel tubs today, I tubbed the car a few years ago but don’t like the tube results so I want to redo them and to do that I want to replace the quarters also.

 

Some flux core wire and a 110 welder it be good as new

 

Send it, tomorrow the big mamma cam arrives

 

fun stuff showing up!

 

Well went to rebuild my tci th350 and install my brake, and found this lovely gem. Only supposed to be weak in third gear, I suppose this could be weak in all gears lol. As much as I couldn’t afford it, I knew I needed to upgrade anyways so I bought the ckc performance mechanical diode drum assembly and the bullet input shaft and drum.

 

Wheel tubs showed up today




Here’s the picture that didn’t upload the other day

 

Ordered a crank scraper from Kevin Johnson, never ran one, curious how that will turn out

 

Junks all done at the machine shop 😍 sonic test results attached for the 3.898 bore lc9

 

It was about to come apart.

 

The car quit moving lol

 

Got the heads scribed for port matching, quite lip they would have without.

 

Soooooooooo much better. Tapered the ports back about an 1” to 1.25 inch depending on how bad the lip was. That should help a ton.

 

What am i missing here man. "346 high compression build" ... but the block in above pic has afm holes