BOLO

iTrader: (40)

Great. I already have a brand new oem GM gaskets somewhere if I can only find them.

SHovV

iTrader: (1)

Those are chiny!

BOLO

iTrader: (40)

For those that run these same valve covers and coil brackets, where did you get your spark plug wires? I purchased a 10mm set from ebay and they were too freakin' short. Let me know which wires to go with. Thanks.

blk00ss

iTrader: (66)

Wtf eBay?? Fire core man. F I R E C O R E


https://www.customwiresets.com/produ...cat=270&page=1


These should be the ones. You want truck length. Which are 13".

SSSTANG#1

iTrader: (14)

Definitely Firecore!

BOLO

iTrader: (40)

Nice! Are those correct length for Proform valve covers? How long? Part #? How do go about getting a set like those?

JakeFusion

iTrader: (7)

Firecore50 8.5mm 13" PF-3007 Spark Plug Wire Set $125

It's in my build list for my 416 Solid Roller...

I have Firecore50 now and they are awesome. Also, I run Manton Series 4 in my engine.

BOLO

iTrader: (40)

Yeah, ebay. I didn''t know what I was thinking

But, thanks for the link. I'm ordering a set now!

JakeFusion

iTrader: (7)

Order the 3007s with the 180 degree boots. You can manipulate them easier. The 135 degree boots I have now and don't like them. Harder to clear the header.

speedtigger

iTrader: (16)

I have custom Firecores also. I had some Granatelli's before that. They are both excellent quality.

SSSTANG#1

iTrader: (14)

Let Ricky know how long you need them to be and he will build them for you.

flintwrench69

iTrader: (11)

https://ls1tech.com/forums/dynamomet...ls3-today.html

BOLO

iTrader: (40)

Thanks again man. Rick suggested a custom length(14") #3009 plug wires. I should have them sometime next week.

BOLO

iTrader: (40)

Manton series 5 3/8".145" wall.
Check out how beefy they look!

SHovV

iTrader: (1)

Those look good. Probably exactly what I'll be getting. Not sure on length yet though. Gonna start measuring later this week

blk00ss

iTrader: (66)

Didn't do the tapered ends?

BOLO

iTrader: (40)

No tapered ends. Al@Manton suggested just to go standard 3/8.
As mentioned, these pushrods are beefy to say the least. No deflection here for sure.
I'm actually in the middle of setting lash this very moment, and let me just say that setting the LLSR cam to zero lash is a piece of cake using the EOIC method. And in addition to the T&D shaftmounts makes it even easier. No need for pre load as in hydraulic lifters, and no need for feeler gauge as in standard solid roller. It's that easy. Set it at zero lash and you're done.
Sorry for the shitty pics. First pic is a valve at full lift, with excellent geometry. Also showing in the other pics, how much more room for even a larger pushrods, but not necessary for this build.

1989GTA

Those push rods look great.

BOLO

iTrader: (40)

Yes they do. Thanks

tadams72

Looking good. Get it fired up already!