LT1 Opti SUCKS!!!!!!!!!!!
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Feb 2010
Location: Channahon, IL
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
LT1 Opti SUCKS!!!!!!!!!!!
This opti system has to be the worst setup in the world. I cannot get the balancer off!!! Anyone run into that problem??? I am ready to push the car out for the garbage truck. Any pointers on how to change the opti without having a stroke??
Trending Topics
#11
10 Second Club
iTrader: (63)
I have Down's syndrome, ADD, and a little man complex, but I just get the right pulley puller and they come right off. Put some axle grease on the crank snout before you put it back on.
Rebuild the opti with an MSD kit or just get an MSD opti. Some people even bitch about the MSD, but mine has been great. Just put red loctite on the rotor screws before you install.
And yes, you can swap it with the damper on, but for me it's been a bitch to line it up when the damper is there.
Rebuild the opti with an MSD kit or just get an MSD opti. Some people even bitch about the MSD, but mine has been great. Just put red loctite on the rotor screws before you install.
And yes, you can swap it with the damper on, but for me it's been a bitch to line it up when the damper is there.
#20
TECH Resident
iTrader: (9)
Join Date: May 2009
Location: Austin/Cedar Park
Posts: 809
Likes: 0
Received 0 Likes
on
0 Posts
if you have a autozone hub puller the bolts they provide are wrong, what you can do is get 3 nuts you might have around the house ( i did ) put the bolt threw the hole and a nut on the back side. should pop right off