Orygun guys?
#2744
11 Second Club
iTrader: (37)
I've been on the hunt for some Weld Prostar wheels with the correct size and backspacing for the narrowed rearend that's going in the car. Finally found some wheels with the correct width/backspacing but they're Weld Draglites. The wheels were in horrible condition, but I brought them back from the dead. These are 15x10 with 4.5" bs.
Here's the before pics.... Notice how badly pitted, oxidized and water spotted they are.
I spent a couple hours with a 4" cotton buff and some polishing compound. Wasn't able to get all the pits out (too deep), but they look a thousand times better IMO....
Mike
Here's the before pics.... Notice how badly pitted, oxidized and water spotted they are.
I spent a couple hours with a 4" cotton buff and some polishing compound. Wasn't able to get all the pits out (too deep), but they look a thousand times better IMO....
Mike
#2748
11 Second Club
iTrader: (37)
Before:
After:
Mike
#2754
TECH Enthusiast
iTrader: (4)
Join Date: Aug 2009
Location: longview, wa
Posts: 651
Likes: 0
Received 0 Likes
on
0 Posts
hey i have an idea, instead of going next weekend i was gonna see if you wanted to wait till the the next weekend, that way i will have all my exhaust done and i should have some D/R's by then and we could both run. what do ya think?
#2758
TECH Apprentice
iTrader: (1)
If ya aint got strano's under your fbody then you aint got ****!!! Badazz vid!
http://www.streetfire.net/video/STRA...-WE_739888.htm
Joseph this one is for you!
http://www.youtube.com/watch?v=V8FW6NAC-Rg
http://www.streetfire.net/video/STRA...-WE_739888.htm
Joseph this one is for you!
http://www.youtube.com/watch?v=V8FW6NAC-Rg