what did you do to your firebird today?
#1541
Got sideways pulling out of my road and got a thumbs up from a sti. Lol but I did clean up my ls6 intake I got for it. The guy that I bought it off of painted it satan black, and did a shitty job. I don't know why you would even paint a black plastic part satan black in the first place though.
#1543
did new rotors and pads on the rear brakes, I wanna beat the crap out of whoever bolted that caliper mounting bracket up the last time, it was on there so tight we broke a ratchet and had to get my dad to bring his propane torch and 1/2" drive breaker bar over so we could get the brackets off, then one of the rotors was rusted to the hub so that took a hammer and some elbow grease, but for the first time in a long time the brake pedal is nice and smooth, also flushed the rear brakes while I was down there.
edit: here are pics of the nasty brake fluid I flushed from the rear lines.
edit: here are pics of the nasty brake fluid I flushed from the rear lines.
Last edited by Daniel Richards; 09-30-2013 at 05:49 PM.
#1548
#1549
Installed my UMI Tubular K-member, Upper and Lower A-arms, UMI Solid Motor Mounts and Viking Double Adjustable shocks. Just need to get an alignment now. Solid Motor Mounts are going to take some getting used to. Not horrible vibes but there are some. Going from beat down 14 year old stockers that have been shaking since my H/C/I swap in 2007 it will be an adjustment.
#1551
Changed out my a/c compressor, pics later, preparing the car for Crusin the Coast 2013 this coming week!
#1553
Changed out my a/c compressor, pics later, preparing the car for Crusin the Coast 2013 this coming week!
Cleaning the dirty bird. Needs a wash badly
#1555
#1558
Not too many. Used air tools for most of it. Only 3 or 4 bolts that I actually had to turn a wrench on cause I could get the impact on. Feels great. Was a bitch and half to align though. Took about 1.5 hours on a digital alignment rack. If I had it to do over I would have got the non-adjustable Lower A-arms. It was just tedious taking the A-arm off, adjusting length, tighten jam nut, bolt in, check camber/caster, repeat.
Solid motor mounts are not as bad as expected. There are some vibes, but not nearly as bad as everyone made out. Overall I'm pleased for sure.
Solid motor mounts are not as bad as expected. There are some vibes, but not nearly as bad as everyone made out. Overall I'm pleased for sure.
#1560
as for me I washed it.