When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Very interested in that info as well. My ABS light has been on since the shell swap was done it it still functioned. However, the last two events I have done the AND has failed on the last runs of the day. The first time it cost me $430 in failed contingency and it likely will again. NEED this fixed
i'm having the same issue, abs inop, brake, and tcs off, lights on. Codes c0550 = ecu malfunction probable cause; failed ebcm (tcs)
& c0896 out of range voltage at the ebtcm probable causes; charging system fault, open or short circuit condition, poor electrical connection, failed relay condition, ignition switch fault.
I'm the original owner and i'm at 137,000 miles. I have had the above codes come on and off for a couple of months, and have since replaced the front wheel hub assembly's that included wheel sensors, replaced alternator, and "just" cleaned the rear sensors for the first time, one had a strand of wire stuck to it (wire not in photo below).
Cleared codes, i'll have to drive it for about a week and see if codes come back, hopefully it was just the dirty rear sensors.
top three aluminum wires were broken (2nd & 3rd photo), lights would come on after engine bay got hot. I used silver epoxy, and added silicone sealant on those three wires. No problems since, you need a steady hand and a microscope to do this.
06/25/2017 Still good with no issues at 191,726 miles.