LS Engine puller plate
Trending Topics
#8
TECH Senior Member
iTrader: (127)
if u gonna pull out the bottom, might as well swap in a tubular kmember while your there.
i have always pulled it out the top with hood in place and with trans attached.
merv, i made one like the one u made, but i had the plates made on a cnc waterjet. with a dust shield also, but i dont think there is a market for them.
qtp and other alredy make similar designs
i have always pulled it out the top with hood in place and with trans attached.
merv, i made one like the one u made, but i had the plates made on a cnc waterjet. with a dust shield also, but i dont think there is a market for them.
qtp and other alredy make similar designs
#13
12 Second Club
iTrader: (12)
like this? 1/4" plate steel. The base is 18.5" x 6", and the vertical plate is 12" x 2.5" with three 1.5" holes. I used the valley cover to mark the bolt holes and drilled them slightly oversized. Note that you have to remove the cam sensor unless you grind it down in the back. $14 for the steel plus weld time, or free if you have some scrap metal chillin' at the shop.
#15
if u gonna pull out the bottom, might as well swap in a tubular kmember while your there.
i have always pulled it out the top with hood in place and with trans attached.
merv, i made one like the one u made, but i had the plates made on a cnc waterjet. with a dust shield also, but i dont think there is a market for them.
qtp and other alredy make similar designs
i have always pulled it out the top with hood in place and with trans attached.
merv, i made one like the one u made, but i had the plates made on a cnc waterjet. with a dust shield also, but i dont think there is a market for them.
qtp and other alredy make similar designs
#16
TECH Apprentice
iTrader: (8)
Join Date: Jun 2008
Location: somerset WI
Posts: 355
Likes: 0
Received 0 Likes
on
0 Posts
I used the TPIS happy hooker. It worked good and the motor slid right into my trans am.
it has a bend it the lifting hook that helps get past the cowil on the 4th gen cars.
http://www.tpis.com/index.php?module...y=Happy+Hooker
it has a bend it the lifting hook that helps get past the cowil on the 4th gen cars.
http://www.tpis.com/index.php?module...y=Happy+Hooker