When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Buddy says what the heck am I gonna do with this heap ?? Mock up block ??
Boat anchor ??
I’m like; hey let’s tear into it and see what’s good. Worst case scenario is a crankshaft known to take Four horse per cube......”Big Bang Theory”. Hot. Rod
So. Here she is. LMFAO
He pulled one head and quit. Lol
Decided to snap some shots bout twenty minutes into the mess
Cant build a 4.8 into a 5.7 without crank and rods.
5.1 is a 3.90X bore 4.8 crank n rods.
Originally Posted by KCS
Sshhhhhhiiiiieeeeeeeeettttttt, dingle ball hone it and let her eat!!!
Both great ideas !!!!
Buddy says. “Hey those rings must have sealed great cuz four cylinders held water really well”.
My guess is after I stone hone these bitches by hand and dingle ball them, a new set of rings should have the proper end gaps for about 20 pounds of boost.
Prolly weld up the head deck notches, cut em’ thirty, lap the valves and assemble with new seals and blue springs
Got a 99’ LS1 Cam, pop an LS2 chain on and shim the ported oil pump
But I do kinda like the 3.900” bore with a 3.268” arm too. We shall see
It’s his engine. My time. Just keepin busy and outta trouble
Why even bother welding them? we have notched mls head gaskets.
I doubt that will clean up with a hone. Ive seen blocks that looked better that needed .020 or more.
The 327 was only impressive because it had a larger bore. Otherwise it would have been no better than a blue 289.
Although i prefer CID, i understand the allure of short strokes. I mean that's what got me through high school...lol
Im only building the 333 because i have a spare 4.8 crank and rods and a spare ls2 block that needed a .030 overbore to clean up a liner that looked better than yours. So kachow, 333.
Still a pretty odd combo but a great platform for testing a few new cams also. Win/win really
Why even bother welding them? we have notched mls head gaskets.
I doubt that will clean up with a hone. Ive seen blocks that looked better that needed .020 or more.
The 327 was only impressive because it had a larger bore. Otherwise it would have been no better than a blue 289.
2.800" stroke versus 3.25"
Originally Posted by tech@WS6store
Although i prefer CID, i understand the allure of short strokes. I mean that's what got me through high school...lol
Im only building the 333 because i have a spare 4.8 crank and rods and a spare ls2 block that needed a .030 overbore to clean up a liner that looked better than yours. So kachow, 333.
Still a pretty odd combo but a great platform for testing a few new cams also. Win/win really
You missed my point. If the 327 didnt have a larger bore with the short stroke it would be no better than a ford small block. It was a jab at ford also
You missed my point. If the 327 didnt have a larger bore with the short stroke it would be no better than a ford small block. It was a jab at ford also
Guess I didn’t understand “larger bore”. Than what ??
Both the 289 blue oval and the 327 Chevy had four inch bores
Just the stroke varied by .450”
No harm though.