Epic SRK B/S thread of 2019
#7764
Finally got to drive my 4300lbs dad mobile, with a few upgrades. 96 Impala SS, LS1, T56 swap.
https://www.youtube.com/watch?v=KUfem8GxAV4
https://www.youtube.com/watch?v=KUfem8GxAV4
The following users liked this post:
NW-99SS (12-03-2020)
#7765
I like yours, that LQ4 should provide the torque needed to get her big *** rolling.
#7767
Fbody BBK long tube headers into a Y pipe, 3" back to a summit glasspack and dumped. Video enhances the drone a bit, it's nasty sounding in person. I wanted to run duals into an H pipe, but there is just no room under that car, and with mine being lowered, I was only going to have about an inch of clearance. I may rework it later, but it's OK for now.
I like yours, that LQ4 should provide the torque needed to get her big *** rolling.
I like yours, that LQ4 should provide the torque needed to get her big *** rolling.
#7768
Header wise, I had no clearance issues to the ground. I had some interference on the passenger side, but a hammer took care of that. It's the trans crossmember that I had to get creative with, and then the floor pans are in the way. Best place to run it is under the driveshaft. My mistake was ordering 3" exhaust ****, because my Y pipe was 3". Had I gone with 2.5", I wouldn't have had the issues.
#7772
10 Second Club
The following users liked this post:
AnnivSS (12-03-2020)
#7775
#7776
#7777
TECH Resident
iTrader: (3)
You would think, but it did come out of the ford camp. It's just nice to see ford finally have a n/a V8 that's proving to give GM a real contender (n/a speaking). I mean their n/a 6.2L left more than it's fair share to be desired, it was quite sad compared to GM's 6.2.
The following users liked this post:
HioSSilver (12-05-2020)
#7779
10 Second Club
iTrader: (8)
Finally got to drive my 4300lbs dad mobile, with a few upgrades. 96 Impala SS, LS1, T56 swap.
https://www.youtube.com/watch?v=KUfem8GxAV4
https://www.youtube.com/watch?v=KUfem8GxAV4
The following users liked this post:
NW-99SS (12-07-2020)