That_One_Person

iTrader: (4)

Any idea how the true duals will be attached to the car? Will drilling into the rear seat area be required with the dumps? Tempted to make a switch if I don't have to put holes in my car.

CoreyD

iTrader: (9)

Interested to see the Duals!

Speed Engineering

iTrader: (35)

The true dual rear exit will not require any drilling etc. The true dual dump can either be bolted or welded to the bottom of the rear floorboard yes.

Thanks
Sean

That_One_Person

iTrader: (4)

Can't wait to see what you guys have in store then. If the rear exit is similar to Kook's I already have a PHB relocate on my car.

rdcamaro

iTrader: (6)

Any update on rear exit true duals, find any pics of them?

Speed Engineering

iTrader: (35)

ETA on both rear exit kits is in January some time.

Thanks
Sean

AntCamp1992

How are these with true duals??

Stew2000

iTrader: (2)

Just picked up the 1 7/8" Race headers and y pipe for my 2000 SS. Quality looks great, will probably have to pick up new clamps since those seem to be the only no quality part with these headers.

wav3form

iTrader: (1)

I was going to order the Phab dumped true duals from ebay but maybe I should hold off until SE release theirs? I'd like to see them before I make a decision.

sokr915

iTrader: (3)

Any plans of tax season deals on the headers?

Speed Engineering

iTrader: (35)

We should hopefully have our true dual kits in this month sometime. We dont usually have any sales on our products sorry.

Thanks
Sean

2ToeRacing

iTrader: (5)

Could some one put up some pictures from the side,I need to see how close they tuck to the floor board. My SLP LT's hang to low.
I will be buying the LT's and true duals when they come out. I need new exhaust so I can lower my car. What kinda stainless are you LT's/duals.... 304?
I have my money ready.....

zachm89

iTrader: (14)

Are there pictures and specs on the dual kits anywhere? If my single 4" doesnt live up to my expectations Ill definitely be in the market for a set of duals.

sokr915

iTrader: (3)

Do you know how much the TDs will be sold for and will a catted version be available?

codyvette

iTrader: (24)

I need new headers and am thinking about this system to replace my Borla with electric cut out. Unfortunately, when my trans gets back from TDP, it's go time and these my not be ready in time.

Speed Engineering

iTrader: (35)

We dont have exact pricing on the true duals yet. However, I do have a few pics from our prototypes that came back a few months ago for test fitting. Hopefully they come in sooner than later.

RGSS

iTrader: (2)

They look great, Sean
Cant wait to order mine.
They look like 3" diameter, is that correct?

2ToeRacing

iTrader: (5)

I see you car has a non-stock upper PHB,will this new system require that or will it work with out it? My money is waiting

Speed Engineering

iTrader: (35)

Yes, both kits are 3", and yes unfortunately there is not enough room. A BMR panhard relocation kit will be needed. We already have both colors in stock for when our kits come in.

Thanks
Sean

zachm89

iTrader: (14)

If you have or whenever you get the chance to post sound clips please do! If my 4" system doesnt work out Ill definitely be in the market for one of these two kits.