View Full Version : Forced Induction
- turbo set up, help?
- Pair of Mitsu TE04s on a 4.8/5.3
- Where to install the oil line restrictors for turbos?
- vortec sc any bigger ?
- Few passes today for the low boost fans..
- lets see your turbos
- RevXtreme 1,000 RWHP video teaser...
- OHIO BOYS...winter fun!
- Who's running a Ford style TB?
- problem with biggest AR on turbo
- Wideband issues with FI....
- Well, it's time for a new turbo.
- FI Fuel System questions
- Seeking advice on forced induction build.....
- Interesting thought... tripple turbo?
- When to change F1A procharger oil?
- turbo repair?
- FI + gas mileage.
- Which turbo is a direct swap for my ITS GT80
- A Few Procharger Questions...
- Procharger or Single Turbo or Twin Turbos?
- MP70 dimensions versus S76?
- Santa Does Like FI :)
- small filter part #
- Itb Fi
- Add cam or up the boost?
- New product*** Turbocharger Speed Sensor kit
- Little preview of FI-X unit......
- piecing together a supercharger kit...is that possible?
- 400inch motor + F1C + SDCE... thoughts/ opinons?
- turbo project about to start-
- STS/low mount oil scavange pumps.
- What Procharger should I run
- not looking for much, but want more than stock
- lower compression with pistons or heads?
- anyone know??
- Porting an LS2 intake for Procharged motor
- How much boost on a stock motor? What is a good turbo cam?
- Horizontal FMIC project
- INCON TURBOS needed mybe!
- Two cams, please choose one.
- 680/700 aps tt, stock ls2
- P1SC to D1SC swap ?s
- GTO APS forged 6.0 ironblock breakin video
- Procharger with stock fans
- Meth ?
- What valve springs are your running for over 600 lift?
- jegs supercharger: worth it or not?
- Best Location For 02's On a turbo car.
- Running in under load procedure?
- single T3 on a trans am?
- Compression ratio and heads, couple questions.
- Hellion style turbo results
- Converter suggestions..D1SC,228/234 cam?
- Squeezed pipes ok?
- Using inexpensive but small SS409 headers as turbo manifold?
- New dyno numbers at 15.5 psi / T-76 / 347ci
- COMPLETELY switching my setup and need advice
- Procharger and BMR alternator bracket?
- How much boost?
- c6 exhaust manifold turbo kit
- durability of injectors, reg, pumps with meth
- big power with e85 and no intercooler?
- *** CARTEK 402 Turbo traps 150MPH ( Street Car ) ***
- Heads for 6.0L procharger motor
- Procharger fan wiring
- 1005 rwhp 03 C5...
- Worth getting 1-7/8" LT's to replace my 1-3/4"?
- How do I build torque with minimal hp gain?
- C5 with F1C
- turbo
- Self Installing the STS kit BUT..... The tuning shop is 120 miles away!!!!
- Who's turbo set-up is this??? Help
- Hope i don't get Flamed for this....
- Twins: sizing for a 5.3
- Plug Issue
- help me with c/r for my fi set up
- So what do you guys think about this?
- Which stroker kit for a single turbo?
- Setting up Compression ratio !!
- new supercharger from JET?
- What do you guys think of this combo before i begin assembly???
- Supercharged Six Speed....
- Methanol+93 vs 100?
- APS TT F-body setup Dyno's
- Turbo GXP @ the Dyno.....
- Post your A2W pics
- Stock engine and Procharger
- 3 bar map not showing boost
- Not LSx, but pimp to say the least.
- Where the F*#$ can someone buy seperate STS parts?
- Single Turbo C6 Vette
- Something fishy w/ this deal?
- Your thoughts about Magnuson Super Chargers?
- The Monster Rear-mount is comming!!! LMR's build! (PICS)
- 8.84@154 shake down.
- big a2w intercoolers what brand?
- MLS Head Gaskets
- intake manifold selection
- Supercharged guys w/ 6spd
- Building up top end for FI motor from shortblock....
- BW - FI/Bullseye/AirWerks/wtf?
- Big thanks FI.com
- Should I install new rings for turbo setup?
- methenal injection
- 2 step
- Help me pick my turbo
- Ummm.. WTF is this
- Blown Nova
- Do turbo blankets work?
- Choosing the right intercooler
- strange timing question
- when 1 power adder isnt enough...
- More Vortech Q's with illustrations.
- PTS.. gregs last name or any employee
- Pre Magna Charger install mileage
- My FI cam choice!
- 393 kit goin turbo to much compression
- best price on a pt88,,
- Whoops, bought too much exhaust wrap
- Vacuum hose sizing for Wg/BOV/Ect
- Help with turbo sizing
- Weird Sound
- So how long does a boosted motor last
- A "new" turbo option for those of you want a GT47-88 but have physical size limits...
- Cam?
- Help! Need Supercharger Install How-To!!
- camshaft for a p-1sc procharger????
- 408 + S91 Hits the Dyno
- Vortech/ATI dampner question.
- engine mods to handle forced induction?
- LS1 Acc. Setups w/ Prochargers
- Anxious for the weekend...
- Upgrade from a S-trim to a procharger
- Meth question...
- C6 Z06 APS Twin Turbo kit
- How Hard is it to install the STS kit?
- Cam for turbo 408
- sts electrical questions
- Radiused Turbo inlets
- New turbo goodies - PICS from PRI!
- GT-47 240 hit the dyno
- Need turbo inlet assembly for old qmp kit?
- turbo on stock bottom end
- regulator from 97 vette rails - vacum/boost regulated?
- OFI Christmas sale!!!
- 383 supercharged + nitrous??
- Procharger P-1sc question
- Why dont you want AIR/EGR ports on your 6.0 manifolds?
- rods/pistons
- engine build input..
- Where do you guys get your liquid turbo cooling from the stock radiator?
- How to keep oil from coming out breathers
- APS F body air filters
- LSX upgrade
- Sway Bar with APS kit????
- what stall to go with(I know this is FI section)
- sts setup?
- How much can i boost? (sts)
- Need help deciding what block to start with
- Procharger questions.
- help me to pull zo6 c6
- New engine on the way, cant wait.
- Some pics of the inside of the old 346 and new 365
- Turbo Camaro Vid
- Running E-85.... What CR with boost?
- FLP Twin Turbo Dodge Magnum SRT-8 spy photos!!!
- truck mani flanges/stainless works
- Converting Internal to External WG
- Why use truck manifolds?
- Procharger w/ cam vids POST THEM!!!
- 454 Whipple supercharger on 496 Vortec???
- 3" cold pipes from a smaller outlet?
- TURBINE as a way of making more power.
- 2.25 V-band clamp?
- Exhaust Wrap
- Sts?
- Finaly!
- what do i need help !!!! single turbo kit
- aftermarket front fascia for TA's
- F1 on stock ls1
- One of our latest projects completed. 921rwhp @18psi
- ? About Rods
- PCV Setup for my LS4 Turbo
- MBC placement....remote turbo?
- remote turbo..WB O2 location??
- for all those that dont think rear mounts work! :)
- Vortech or STS?
- Turbo supports
- Turbo pipes in atmosphere or back into exhaust?
- 5inch down pipes
- 853 Heads Ms3 Cam And Boost?
- HAHAhaha
- Turbo for stock ls1?
- My Camaro 69 build
- slp long tubes
- pushing coolant into overflow?
- 110 LSA for a procharged setup???
- LS3 ATI ProChargers!
- Project build. Need help
- Turbo seems big enough, just making sure!
- Bought a used Procharger and missing parts need help
- 10 12 or cog set up for f-body
- Need some help finishing this up
- Vortech Supercharger Rebate
- Got a couple questions with my STS turbo, Gt67 max boost, meth injection?
- Do you lose boost with headers?
- Procharger Crank Pulley
- Is the stock oil pump going to be good for twin turbos?
- Turbo Pop
- Procharger??
- Wrapping up my engine/turbo setup... Have a couple ?'s
- Checkout this boosted monster!
- edelbrock carb intake users?
- Got My F1R Today
- best turbo to replace 76GTS?
- 408 Needs Turbo
- AFR heads,spring life and high lift cam.
- Oil Leakage, Blow-By! Going Back to NA!
- A new twist - Baby Turbo
- Progress pics/ truck manifold setup
- F/I cam question............
- 408 sts with no cats way to loud..What muffler do you sts guys run?
- Boost Gauge
- Is this turbo system any good??????
- 50/75hp NOS on a turbo LSx... what will happen?
- Any room for pillar gauges with a Wolfe 10 point cage?
- size and hp use to turn a F-1A compared to D-1SC
- Stock 317/6.0L Head questions...
- AFR 225 large bore on a small bore block with boost?
- belt driven supercharger
- i have a fan???
- LT1 Turbo Cam
- What do i do?
- Truck manifold question
- 6.0L for $1500?
- Carbed LS1 w/ProCharger in 67 Chevelle
- Wormboy @ HMP runs FAST...
- How much am I leaving on the table running the OEM STS hotside?
- Exhaust limits with Forced induction?
- Some advice from the procharger guys please
- What did i break???
- TR's Blower cam?
- turbonetics rebuilds..who does them??
- Location for WG
- O2 Sensor locations?
- Who here has an APS Kit?
- How did everyone relocate the alt?
- new pics of my destroyed bottom end
- What heads to buy, AFR 225's or ET 225's?