View Full Version : Forced Induction
- Map sensor questions
- Car dynoed low numbers whats wrong?
- cog belts...
- good heads for 98 C5 magnuson
- from ls1 to ls6 heads/cam
- Blower Cam for LT1
- horsepowertv today.
- Question about STS Turbo
- best heads for boost?
- MMS crank pulley
- Newbie Question
- Anyone have SC HP Power Loss #'s for ATI or Vortech?
- Boost Creep - What causes it?
- Why can't I get my QMP kit to finally work?
- supercharged dyno #'s...
- Turbo going on Sunday, need tuning advise...
- Anyone using Non-Stock Tensioner for their SC??
- Intercooler questions .
- Will my combo make my 600rwhp goal?
- Chipping away...
- Yet Another STS Thread
- Think the car was hurt today....
- SMC solenoid? I need one.
- just got off the phone with PTK
- Incon Turbo Hose? Tom Porter?
- Boost Controller with a Centrifugal SC
- MAF placement
- Turbo'd...or Procharged...that is the question
- Ready to buy my turbo, now where?
- Verify this vendor please
- Vortech V9 aftercooler on 98 LS1/SAS problems
- N20 to TURBO 2!
- where to buy methanol?
- Were to buy Mandrel 90's online??
- STS Featured
- Largest Blower experience with Vortech Aftercooler?
- maxed maf idea
- turbo fuel system help
- STS news flash
- Too much boost and Pump Gas Not Good! Meth/Wide Band!
- Fs: Cammotion Turbo Cam
- 5psi on a stock F-body
- LS2 not FI bound?
- Fuel system help
- Anyone who installed a Procharger
- what set up???
- lookin for a turbo kit..
- STS and Z06?
- question for the big HP guys...
- mls 6.0 head gasket set p/n
- Fm13 And D1sc
- What's the max effective CR your motor can handle?
- How much boost before pump gas will not work?
- WTB: ATI idler pulley
- 1500 HP go cart? can that be real
- Low boost in LS1's
- Updates to Boosted List - Help me with Info
- Ordered a few things today
- Would high ratio rockers do much for me?
- STS for a Vette
- Couple things for sale if anyone is interested
- STS / jlturbo.com kit on my 408?
- STS Questions for the DYIer
- Borla XR-1 or Dynomax Bullet for turbo car?
- Good/bad day at the track...
- pics of my custom twin intercooler piping
- A/F & timing with supercharger???
- STS owners, before and after times/#'s Please
- re dynoed today
- Over Boost.... Need Help
- Car is now at QMP.
- Why isn't a Boost-A-Pump or MSD more popular here?
- Intercooler Idea
- pre TB intercooler piping, 3.0, 3.5 or 4.0?
- big power pcv- 3x power = ?
- CC'd my #317 heads. Strange results.
- sts kit pics (not installed)
- turbos don't need lotsa gear
- What size injectors?
- Well I think my luck has run out..
- Going FI
- ATI race ready Bypass or HKS SSQV BOV ?
- STS Dyno Numbers *Complete*
- humm, installed fuel pressure gauge and this is weird...
- turo timer for LS1
- Incon Owners - Reroute Intake Tubing Into Turbo?
- Turbo vs Super charger????
- very, very nice turbo setup on camaro
- For a SC which is better.....
- FMIC went to the track
- FS:ATI Intercoolers, piping, and Polished Plenum
- T-Trim + V2 SQ Hybrid
- blower cam
- ho hum....
- Started project TT (Pics)
- Big MPH, Little guy.
- ATI tuned and dynoed moved up a little more
- Project Update - D1SC Home Kit
- Some changes........
- Help - Fluidampr Problems?
- LS1 turbos extinct???
- TTI Race Kit on the road!!!
- Technical Help: Bleeding Boost
- Vids of my car 5.04
- Vortech Pulley and LS6 Ported Oil pump?
- which setup is a better choice??
- replacement for vortech water pump
- Pro-M questions
- Thinking of selling my turbotech T76 kit
- N20 to TURBO!
- Head unit and changes in cubes
- Wow! Cudos to the Admins!
- sts exhaust
- Which TR55 for blown 5.3L?
- Dynoed the T76.
- Did some logging with the FMIC...few questions..
- hi i want to know some thing ?
- turbo hot parts???
- boost drop again
- STS Turbo Owners - Please Respond
- vortech question
- P1sc guys running 7lb crank...3.2 blower?? belt slippage?
- ati guys 500+ inside
- Stall Speeds N/A vs. FI
- Which Blow off valve is this (vid inside)
- AP Engineering Shop Car Update
- video of shakedown runs...
- what would be better, turbo or supercharger?
- spercharger options
- supercharger sounds
- Anybody have problems with their Autometer guages?
- Difference between Bypass valve and BOV
- anyone w/ vortech have an ultra z hood?
- Who got the highest boost readings from a D-1SC?
- need knowledgeable opinions on forced induction!!
- pcv/breather q's again
- Bigger intercooler results!
- More updates
- Initial SDCE Tensioner Results
- Jet pump, For Scavange on remote turbo?
- biggest cam for 6-7lbs boost?
- drama race angle 2 part 2.
- need turbo help please
- oil pressure for a turbo, Jose, Rob, anyone???
- installed radix
- turbo cam specs what do u think?
- WarBirds Old QMP Turbo kit.. Dyno# inside
- need v9 g trim head unit
- Has anyone rebuilt their D1-SC on their own?
- D-ISC 5 # kit and (stage 2) 6.0 liter heads
- HKS BOV's inside
- What are the HP advantages to the STS kit?
- Update and Shakedown passes.
- Turbo ls1?
- Calculating impeller speeds
- Couple of shakedown runs...
- forged or stock intenals for my set up?
- Oil In Intake
- Sold my '01 Formula (ATI Procharger)
- Blower is on and perfectly functioning ... one last question
- Rough lb/min -> rwhp or CFM -> rwhp calc?
- Front Mount Intercooler install DONE! "FMIC"
- What's a Safe A/F mixture on a D-1SC
- ditching the d-1sc and going with f-1r...
- new setup and new tune coming
- 3.4" 8 rib blower pulley for sale
- found the problem but its very weird!! -- need some help
- Finally installed my Procharger ... have a few questions
- Methanol injection questions
- STS Dyno Numbers *Incomplete*
- PSJ.. exhaust question
- mototron injector GP
- What size injectors are you FI guy running?
- Loud grinding noise from D-1SC
- Quick Question...
- So I made some shake down passes today....
- rpm to full boost
- GM MLS gaskets and Copper Oring??
- chroming a satin vortech???
- Weldon 9200 Oil Pump GM Part #
- need some help...im unsure
- Turbo experts - Wastegate question for you.
- Dual Waste Gates
- Boost Controller Questions
- What mod to do next?
- Supercharger on my ARE 436 stroker.........
- FMIC install started....pics in here...
- Soon to start project. Just want some input.
- need help please -- problems with twin turbo setup still
- p1sc ?
- All ATI and Vortech superchargers on sale!
- Magnuson's GTO superchargers are shipping!
- Any Disadvantages to oversizing intercooler?
- Who has installed an ATI damper?
- anyone got some pics of their vortech radiator installed?
- anyone have install directions for 2 step?
- Vortech tech questions..
- STS getting installed today :-)
- It's been a while
- fuel pressure, head bolt torque question
- want a turbo/supercharger kit......
- New Gto heads/cam/intake and supercharged
- heavy corosion or ash in exhaust ports(pic's), looks scary to me
- TR224 cam for blower?
- question for you turbo guys
- air filter and water or under hood and hot?
- Pictures of the 1560 HP Wheel 2 Wheel 402ci
- Newb q, how are you folks tuning your FP for WOT with stock pcm?
- Min Fuel Pressure for WOT on S/C LS1's
- anyone with incon kit or CAS kit have a questoin
- vortech installed, is it ok to drive an hour w/o tuning?
- Tuning after Turbo's
- Comp 918's with .571 lift
- good compression ratio and cam specs to run a turbo on?
- What heads do I need? TR 224 114 cam. Need some help please.
- ATI P-1SC or D-1
- Info for bigger K&N Filters inside
- Turbo kits for the lt1
- Air-Water Coolers
- Need more fuel suggestions.
- Now this is a LS1 Turbo..
- STS ordered
- a newbie question
- blower questions
- Help!!!!
- WTB: steering hose that comes w/ vortech
- What's a good cam and heads package for FI?
- PVC question?
- Ran with new kit.... need advice now please.
- Project Twin Turbo begins today.
- Turbo/Vortec/Procharger Serious Question
- How much boost are the 6 rib systems holding??
- Are Master power turbos OK?
- Six Liter TEA Heads for Sale
- Garrett T3/4 hybrid turbo
- STS People??
- Need sugestions for new single turbo project.
- Paging NASTY-TA (Kyle)
- anyone else have there plastic ati plenum explode??
- who has ATI twin cores for sale?
- You guys were right!
- How much boost are you guys running on pump vs gas?
- Deletion kit??
- MM, when you gonna try for 140+ mph?
- Injector Question
- SDCE Spring Tensioner... It works!
- looking for turbonetics catalog on pdf
- Need suggestions for a cam with a Whippled 5.3
- Spring Tensioner users
- My car is at Wheel to Wheel now!